| CONFIG_ARM=y |
| CONFIG_ARCH_MX6=y |
| CONFIG_SYS_TEXT_BASE=0x17800000 |
| CONFIG_SPL_GPIO_SUPPORT=y |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y |
| CONFIG_NR_DRAM_BANKS=1 |
| CONFIG_ENV_SIZE=0x4000 |
| CONFIG_ENV_OFFSET=0x100000 |
| CONFIG_ENV_SECT_SIZE=0x10000 |
| CONFIG_SYS_SPI_U_BOOT_OFFS=0x31400 |
| CONFIG_MX6Q=y |
| CONFIG_MX6_OCRAM_256KB=y |
| CONFIG_TARGET_PCM058=y |
| CONFIG_DM_GPIO=y |
| CONFIG_SPL_DM_SPI=y |
| CONFIG_DEFAULT_DEVICE_TREE="imx6q-phytec-mira-rdk-nand" |
| CONFIG_SPL_TEXT_BASE=0x00908000 |
| CONFIG_SPL_MMC_SUPPORT=y |
| CONFIG_SPL_SERIAL_SUPPORT=y |
| CONFIG_SPL=y |
| CONFIG_ENV_OFFSET_REDUND=0x110000 |
| CONFIG_SPL_LIBDISK_SUPPORT=y |
| CONFIG_SPL_SPI_FLASH_SUPPORT=y |
| CONFIG_SPL_SPI_SUPPORT=y |
| CONFIG_CMD_HDMIDETECT=y |
| CONFIG_DISTRO_DEFAULTS=y |
| CONFIG_FIT=y |
| CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/mach-imx/spl_sd.cfg" |
| CONFIG_BOOTDELAY=3 |
| # CONFIG_USE_BOOTCOMMAND is not set |
| CONFIG_DISPLAY_BOARDINFO_LATE=y |
| CONFIG_SPL_BOARD_INIT=y |
| CONFIG_SPL_SEPARATE_BSS=y |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x18a |
| CONFIG_SPL_DMA=y |
| CONFIG_SPL_FS_EXT4=y |
| CONFIG_SPL_DM_SPI_FLASH=y |
| CONFIG_SPL_SPI_LOAD=y |
| CONFIG_SPL_WATCHDOG_SUPPORT=y |
| CONFIG_SPL_YMODEM_SUPPORT=y |
| # CONFIG_CMD_FLASH is not set |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_NAND_TRIMFFS=y |
| # CONFIG_CMD_PINMUX is not set |
| CONFIG_CMD_CACHE=y |
| CONFIG_CMD_EXT4_WRITE=y |
| CONFIG_CMD_MTDPARTS=y |
| CONFIG_MTDIDS_DEFAULT="nand0=gpmi-nand" |
| CONFIG_MTDPARTS_DEFAULT="mtdparts=gpmi-nand:-(rootfs)" |
| CONFIG_CMD_UBI=y |
| # CONFIG_SPL_PARTITION_UUIDS is not set |
| CONFIG_SPL_OF_CONTROL=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_ENV_IS_IN_SPI_FLASH=y |
| CONFIG_SYS_REDUNDAND_ENVIRONMENT=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_SPL_DM=y |
| CONFIG_BOUNCE_BUFFER=y |
| CONFIG_DM_I2C=y |
| CONFIG_SYS_I2C_MXC=y |
| CONFIG_FSL_USDHC=y |
| CONFIG_MTD=y |
| CONFIG_DM_MTD=y |
| CONFIG_MTD_RAW_NAND=y |
| CONFIG_SYS_NAND_USE_FLASH_BBT=y |
| CONFIG_NAND_MXS=y |
| CONFIG_NAND_MXS_DT=y |
| CONFIG_DM_SPI_FLASH=y |
| CONFIG_SF_DEFAULT_MODE=0 |
| CONFIG_SF_DEFAULT_SPEED=20000000 |
| CONFIG_SPI_FLASH_STMICRO=y |
| CONFIG_PHYLIB=y |
| CONFIG_PHY_MICREL=y |
| CONFIG_PHY_MICREL_KSZ90X1=y |
| CONFIG_DM_ETH=y |
| CONFIG_DM_MDIO=y |
| CONFIG_FEC_MXC=y |
| CONFIG_MII=y |
| CONFIG_PINCTRL=y |
| CONFIG_PINCONF=y |
| # CONFIG_PINCONF_RECURSIVE is not set |
| CONFIG_SPL_PINCTRL=y |
| CONFIG_SPL_PINCONF=y |
| # CONFIG_SPL_PINCONF_RECURSIVE is not set |
| CONFIG_PINCTRL_IMX6=y |
| CONFIG_DM_SERIAL=y |
| CONFIG_MXC_UART=y |
| CONFIG_SPI=y |
| CONFIG_DM_SPI=y |
| CONFIG_MXC_SPI=y |
| # CONFIG_SPL_WDT is not set |