blob: 641da515c8f3ed63436fd59249da1d5adfee8907 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0
/*
* Copyright (c) 2016 Google, Inc
*
* From coreboot src/soc/intel/broadwell/sata.c
*/
#include <common.h>
#include <dm.h>
#include <log.h>
#include <asm/gpio.h>
#include <asm/io.h>
#include <asm/intel_regs.h>
#include <asm/lpc_common.h>
#include <asm/pch_common.h>
#include <asm/pch_common.h>
#include <asm/arch/pch.h>
#include <linux/delay.h>
struct sata_platdata {
int port_map;
uint port0_gen3_tx;
uint port1_gen3_tx;
uint port0_gen3_dtle;
uint port1_gen3_dtle;
/*
* SATA DEVSLP Mux
* 0 = port 0 DEVSLP on DEVSLP0/GPIO33
* 1 = port 3 DEVSLP on DEVSLP0/GPIO33
*/
int devslp_mux;
/*
* DEVSLP Disable
* 0: DEVSLP is enabled
* 1: DEVSLP is disabled
*/
int devslp_disable;
};
static void broadwell_sata_init(struct udevice *dev)
{
struct sata_platdata *plat = dev_get_platdata(dev);
u32 reg32;
u8 *abar;
u16 reg16;
int port;
debug("SATA: Initializing controller in AHCI mode.\n");
/* Set timings */
dm_pci_write_config16(dev, IDE_TIM_PRI, IDE_DECODE_ENABLE);
dm_pci_write_config16(dev, IDE_TIM_SEC, IDE_DECODE_ENABLE);
/* for AHCI, Port Enable is managed in memory mapped space */
dm_pci_read_config16(dev, 0x92, &reg16);
reg16 &= ~0xf;
reg16 |= 0x8000 | plat->port_map;
dm_pci_write_config16(dev, 0x92, reg16);
udelay(2);
/* Setup register 98h */
dm_pci_read_config32(dev, 0x98, &reg32);
reg32 &= ~((1 << 31) | (1 << 30));
reg32 |= 1 << 23;
reg32 |= 1 << 24; /* Enable MPHY Dynamic Power Gating */
dm_pci_write_config32(dev, 0x98, reg32);
/* Setup register 9Ch */
reg16 = 0; /* Disable alternate ID */
reg16 = 1 << 5; /* BWG step 12 */
dm_pci_write_config16(dev, 0x9c, reg16);
/* SATA Initialization register */
reg32 = 0x183;
reg32 |= (plat->port_map ^ 0xf) << 24;
reg32 |= (plat->devslp_mux & 1) << 15;
dm_pci_write_config32(dev, 0x94, reg32);
/* Initialize AHCI memory-mapped space */
dm_pci_read_config32(dev, PCI_BASE_ADDRESS_5, &reg32);
abar = (u8 *)reg32;
debug("ABAR: %p\n", abar);
/* CAP (HBA Capabilities) : enable power management */
clrsetbits_le32(abar + 0x00, 0x00020060 /* SXS+EMS+PMS */,
0x0c006000 /* PSC+SSC+SALP+SSS */ |
1 << 18); /* SAM: SATA AHCI MODE ONLY */
/* PI (Ports implemented) */
writel(plat->port_map, abar + 0x0c);
(void) readl(abar + 0x0c); /* Read back 1 */
(void) readl(abar + 0x0c); /* Read back 2 */
/* CAP2 (HBA Capabilities Extended)*/
if (plat->devslp_disable) {
clrbits_le32(abar + 0x24, 1 << 3);
} else {
/* Enable DEVSLP */
setbits_le32(abar + 0x24, 1 << 5 | 1 << 4 | 1 << 3 | 1 << 2);
for (port = 0; port < 4; port++) {
if (!(plat->port_map & (1 << port)))
continue;
/* DEVSLP DSP */
setbits_le32(abar + 0x144 + (0x80 * port), 1 << 1);
}
}
/* Static Power Gating for unused ports */
reg32 = readl(RCB_REG(0x3a84));
/* Port 3 and 2 disabled */
if ((plat->port_map & ((1 << 3)|(1 << 2))) == 0)
reg32 |= (1 << 24) | (1 << 26);
/* Port 1 and 0 disabled */
if ((plat->port_map & ((1 << 1)|(1 << 0))) == 0)
reg32 |= (1 << 20) | (1 << 18);
writel(reg32, RCB_REG(0x3a84));
/* Set Gen3 Transmitter settings if needed */
if (plat->port0_gen3_tx)
pch_iobp_update(SATA_IOBP_SP0_SECRT88,
~(SATA_SECRT88_VADJ_MASK <<
SATA_SECRT88_VADJ_SHIFT),
(plat->port0_gen3_tx &
SATA_SECRT88_VADJ_MASK)
<< SATA_SECRT88_VADJ_SHIFT);
if (plat->port1_gen3_tx)
pch_iobp_update(SATA_IOBP_SP1_SECRT88,
~(SATA_SECRT88_VADJ_MASK <<
SATA_SECRT88_VADJ_SHIFT),
(plat->port1_gen3_tx &
SATA_SECRT88_VADJ_MASK)
<< SATA_SECRT88_VADJ_SHIFT);
/* Set Gen3 DTLE DATA / EDGE registers if needed */
if (plat->port0_gen3_dtle) {
pch_iobp_update(SATA_IOBP_SP0DTLE_DATA,
~(SATA_DTLE_MASK << SATA_DTLE_DATA_SHIFT),
(plat->port0_gen3_dtle & SATA_DTLE_MASK)
<< SATA_DTLE_DATA_SHIFT);
pch_iobp_update(SATA_IOBP_SP0DTLE_EDGE,
~(SATA_DTLE_MASK << SATA_DTLE_EDGE_SHIFT),
(plat->port0_gen3_dtle & SATA_DTLE_MASK)
<< SATA_DTLE_EDGE_SHIFT);
}
if (plat->port1_gen3_dtle) {
pch_iobp_update(SATA_IOBP_SP1DTLE_DATA,
~(SATA_DTLE_MASK << SATA_DTLE_DATA_SHIFT),
(plat->port1_gen3_dtle & SATA_DTLE_MASK)
<< SATA_DTLE_DATA_SHIFT);
pch_iobp_update(SATA_IOBP_SP1DTLE_EDGE,
~(SATA_DTLE_MASK << SATA_DTLE_EDGE_SHIFT),
(plat->port1_gen3_dtle & SATA_DTLE_MASK)
<< SATA_DTLE_EDGE_SHIFT);
}
/*
* Additional Programming Requirements for Power Optimizer
*/
/* Step 1 */
pch_common_sir_write(dev, 0x64, 0x883c9003);
/* Step 2: SIR 68h[15:0] = 880Ah */
reg32 = pch_common_sir_read(dev, 0x68);
reg32 &= 0xffff0000;
reg32 |= 0x880a;
pch_common_sir_write(dev, 0x68, reg32);
/* Step 3: SIR 60h[3] = 1 */
reg32 = pch_common_sir_read(dev, 0x60);
reg32 |= (1 << 3);
pch_common_sir_write(dev, 0x60, reg32);
/* Step 4: SIR 60h[0] = 1 */
reg32 = pch_common_sir_read(dev, 0x60);
reg32 |= (1 << 0);
pch_common_sir_write(dev, 0x60, reg32);
/* Step 5: SIR 60h[1] = 1 */
reg32 = pch_common_sir_read(dev, 0x60);
reg32 |= (1 << 1);
pch_common_sir_write(dev, 0x60, reg32);
/* Clock Gating */
pch_common_sir_write(dev, 0x70, 0x3f00bf1f);
pch_common_sir_write(dev, 0x54, 0xcf000f0f);
pch_common_sir_write(dev, 0x58, 0x00190000);
clrsetbits_le32(RCB_REG(0x333c), 0x00300000, 0x00c00000);
dm_pci_read_config32(dev, 0x300, &reg32);
reg32 |= 1 << 17 | 1 << 16 | 1 << 19;
reg32 |= 1 << 31 | 1 << 30 | 1 << 29;
dm_pci_write_config32(dev, 0x300, reg32);
dm_pci_read_config32(dev, 0x98, &reg32);
reg32 |= 1 << 29;
dm_pci_write_config32(dev, 0x98, reg32);
/* Register Lock */
dm_pci_read_config32(dev, 0x9c, &reg32);
reg32 |= 1 << 31;
dm_pci_write_config32(dev, 0x9c, reg32);
}
static int broadwell_sata_enable(struct udevice *dev)
{
struct sata_platdata *plat = dev_get_platdata(dev);
struct gpio_desc desc;
u16 map;
int ret;
/*
* Set SATA controller mode early so the resource allocator can
* properly assign IO/Memory resources for the controller.
*/
map = 0x0060;
map |= (plat->port_map ^ 0x3f) << 8;
dm_pci_write_config16(dev, 0x90, map);
ret = gpio_request_by_name(dev, "reset-gpio", 0, &desc, GPIOD_IS_OUT);
if (ret)
return ret;
return 0;
}
static int broadwell_sata_ofdata_to_platdata(struct udevice *dev)
{
struct sata_platdata *plat = dev_get_platdata(dev);
const void *blob = gd->fdt_blob;
int node = dev_of_offset(dev);
plat->port_map = fdtdec_get_int(blob, node, "intel,sata-port-map", 0);
plat->port0_gen3_tx = fdtdec_get_int(blob, node,
"intel,sata-port0-gen3-tx", 0);
return 0;
}
static int broadwell_sata_probe(struct udevice *dev)
{
if (!(gd->flags & GD_FLG_RELOC))
return broadwell_sata_enable(dev);
else
broadwell_sata_init(dev);
return 0;
}
static const struct udevice_id broadwell_ahci_ids[] = {
{ .compatible = "intel,wildcatpoint-ahci" },
{ }
};
U_BOOT_DRIVER(ahci_broadwell_drv) = {
.name = "ahci_broadwell",
.id = UCLASS_AHCI,
.of_match = broadwell_ahci_ids,
.ofdata_to_platdata = broadwell_sata_ofdata_to_platdata,
.probe = broadwell_sata_probe,
.platdata_auto_alloc_size = sizeof(struct sata_platdata),
};