blob: 9dd0afb4bcacd905e2287a52acdd011d09182b26 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (C) 2012 Altera Corporation <www.altera.com>
*/
#include <common.h>
#include <asm/io.h>
#include <asm/pl310.h>
#include <asm/u-boot.h>
#include <asm/utils.h>
#include <image.h>
#include <asm/arch/reset_manager.h>
#include <spl.h>
#include <asm/arch/system_manager.h>
#include <asm/arch/freeze_controller.h>
#include <asm/arch/clock_manager.h>
#include <asm/arch/misc.h>
#include <asm/arch/scan_manager.h>
#include <asm/arch/sdram.h>
#include <asm/sections.h>
#include <debug_uart.h>
#include <fdtdec.h>
#include <watchdog.h>
#include <dm/uclass.h>
DECLARE_GLOBAL_DATA_PTR;
static struct pl310_regs *const pl310 =
(struct pl310_regs *)CONFIG_SYS_PL310_BASE;
static const struct socfpga_system_manager *sysmgr_regs =
(struct socfpga_system_manager *)SOCFPGA_SYSMGR_ADDRESS;
u32 spl_boot_device(void)
{
const u32 bsel = readl(&sysmgr_regs->bootinfo);
switch (SYSMGR_GET_BOOTINFO_BSEL(bsel)) {
case 0x1: /* FPGA (HPS2FPGA Bridge) */
return BOOT_DEVICE_RAM;
case 0x2: /* NAND Flash (1.8V) */
case 0x3: /* NAND Flash (3.0V) */
return BOOT_DEVICE_NAND;
case 0x4: /* SD/MMC External Transceiver (1.8V) */
case 0x5: /* SD/MMC Internal Transceiver (3.0V) */
return BOOT_DEVICE_MMC1;
case 0x6: /* QSPI Flash (1.8V) */
case 0x7: /* QSPI Flash (3.0V) */
return BOOT_DEVICE_SPI;
default:
printf("Invalid boot device (bsel=%08x)!\n", bsel);
hang();
}
}
#ifdef CONFIG_SPL_MMC_SUPPORT
u32 spl_boot_mode(const u32 boot_device)
{
#if defined(CONFIG_SPL_FS_FAT) || defined(CONFIG_SPL_FS_EXT4)
return MMCSD_MODE_FS;
#else
return MMCSD_MODE_RAW;
#endif
}
#endif
static void socfpga_pl310_clear(void)
{
u32 mask = 0xff, ena = 0;
icache_enable();
/* Disable the L2 cache */
clrbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN);
writel(0x111, &pl310->pl310_tag_latency_ctrl);
writel(0x121, &pl310->pl310_data_latency_ctrl);
/* enable BRESP, instruction and data prefetch, full line of zeroes */
setbits_le32(&pl310->pl310_aux_ctrl,
L310_AUX_CTRL_DATA_PREFETCH_MASK |
L310_AUX_CTRL_INST_PREFETCH_MASK |
L310_SHARED_ATT_OVERRIDE_ENABLE);
/* Enable the L2 cache */
ena = readl(&pl310->pl310_ctrl);
ena |= L2X0_CTRL_EN;
/*
* Invalidate the PL310 L2 cache. Keep the invalidation code
* entirely in L1 I-cache to avoid any bus traffic through
* the L2.
*/
asm volatile(
".align 5 \n"
" b 3f \n"
"1: str %1, [%4] \n"
" dsb \n"
" isb \n"
" str %0, [%2] \n"
" dsb \n"
" isb \n"
"2: ldr %0, [%2] \n"
" cmp %0, #0 \n"
" bne 2b \n"
" str %0, [%3] \n"
" dsb \n"
" isb \n"
" b 4f \n"
"3: b 1b \n"
"4: nop \n"
: "+r"(mask), "+r"(ena)
: "r"(&pl310->pl310_inv_way),
"r"(&pl310->pl310_cache_sync), "r"(&pl310->pl310_ctrl)
: "memory", "cc");
/* Disable the L2 cache */
clrbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN);
}
void board_init_f(ulong dummy)
{
const struct cm_config *cm_default_cfg = cm_get_default_config();
unsigned long reg;
int ret;
struct udevice *dev;
/*
* First C code to run. Clear fake OCRAM ECC first as SBE
* and DBE might triggered during power on
*/
reg = readl(&sysmgr_regs->eccgrp_ocram);
if (reg & SYSMGR_ECC_OCRAM_SERR)
writel(SYSMGR_ECC_OCRAM_SERR | SYSMGR_ECC_OCRAM_EN,
&sysmgr_regs->eccgrp_ocram);
if (reg & SYSMGR_ECC_OCRAM_DERR)
writel(SYSMGR_ECC_OCRAM_DERR | SYSMGR_ECC_OCRAM_EN,
&sysmgr_regs->eccgrp_ocram);
memset(__bss_start, 0, __bss_end - __bss_start);
socfpga_sdram_remap_zero();
socfpga_pl310_clear();
debug("Freezing all I/O banks\n");
/* freeze all IO banks */
sys_mgr_frzctrl_freeze_req();
/* Put everything into reset but L4WD0. */
socfpga_per_reset_all();
if (!socfpga_is_booting_from_fpga()) {
/* Put FPGA bridges into reset too. */
socfpga_bridges_reset(1);
}
socfpga_per_reset(SOCFPGA_RESET(OSC1TIMER0), 0);
timer_init();
debug("Reconfigure Clock Manager\n");
/* reconfigure the PLLs */
if (cm_basic_init(cm_default_cfg))
hang();
/* Enable bootrom to configure IOs. */
sysmgr_config_warmrstcfgio(1);
/* configure the IOCSR / IO buffer settings */
if (scan_mgr_configure_iocsr())
hang();
sysmgr_config_warmrstcfgio(0);
/* configure the pin muxing through system manager */
sysmgr_config_warmrstcfgio(1);
sysmgr_pinmux_init();
sysmgr_config_warmrstcfgio(0);
/* De-assert reset for bridges based on handoff */
socfpga_bridges_reset(0);
debug("Unfreezing/Thaw all I/O banks\n");
/* unfreeze / thaw all IO banks */
sys_mgr_frzctrl_thaw_req();
#ifdef CONFIG_DEBUG_UART
socfpga_per_reset(SOCFPGA_RESET(UART0), 0);
debug_uart_init();
#endif
ret = spl_early_init();
if (ret) {
debug("spl_early_init() failed: %d\n", ret);
hang();
}
ret = uclass_get_device(UCLASS_RESET, 0, &dev);
if (ret)
debug("Reset init failed: %d\n", ret);
/* enable console uart printing */
preloader_console_init();
ret = uclass_get_device(UCLASS_RAM, 0, &dev);
if (ret) {
debug("DRAM init failed: %d\n", ret);
hang();
}
if (!socfpga_is_booting_from_fpga())
socfpga_bridges_reset(1);
}