| /* |
| * board/renesas/gose/gose.c |
| * |
| * Copyright (C) 2014 Renesas Electronics Corporation |
| * |
| * SPDX-License-Identifier: GPL-2.0 |
| */ |
| |
| #include <common.h> |
| #include <malloc.h> |
| #include <dm.h> |
| #include <dm/platform_data/serial_sh.h> |
| #include <environment.h> |
| #include <asm/processor.h> |
| #include <asm/mach-types.h> |
| #include <asm/io.h> |
| #include <linux/errno.h> |
| #include <asm/arch/sys_proto.h> |
| #include <asm/gpio.h> |
| #include <asm/arch/rmobile.h> |
| #include <asm/arch/rcar-mstp.h> |
| #include <asm/arch/sh_sdhi.h> |
| #include <netdev.h> |
| #include <miiphy.h> |
| #include <i2c.h> |
| #include "qos.h" |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| #define CLK2MHZ(clk) (clk / 1000 / 1000) |
| void s_init(void) |
| { |
| struct rcar_rwdt *rwdt = (struct rcar_rwdt *)RWDT_BASE; |
| struct rcar_swdt *swdt = (struct rcar_swdt *)SWDT_BASE; |
| u32 stc; |
| |
| /* Watchdog init */ |
| writel(0xA5A5A500, &rwdt->rwtcsra); |
| writel(0xA5A5A500, &swdt->swtcsra); |
| |
| /* CPU frequency setting. Set to 1.5GHz */ |
| stc = ((1500 / CLK2MHZ(CONFIG_SYS_CLK_FREQ)) - 1) << PLL0_STC_BIT; |
| clrsetbits_le32(PLL0CR, PLL0_STC_MASK, stc); |
| |
| /* QoS */ |
| qos_init(); |
| } |
| |
| #define TMU0_MSTP125 (1 << 25) |
| #define SCIF0_MSTP721 (1 << 21) |
| #define ETHER_MSTP813 (1 << 13) |
| |
| #define SDHI0_MSTP314 (1 << 14) |
| #define SDHI1_MSTP312 (1 << 12) |
| #define SDHI2_MSTP311 (1 << 11) |
| |
| #define SD1CKCR 0xE6150078 |
| #define SD2CKCR 0xE615026C |
| #define SD_97500KHZ 0x7 |
| |
| int board_early_init_f(void) |
| { |
| /* TMU0 */ |
| mstp_clrbits_le32(MSTPSR1, SMSTPCR1, TMU0_MSTP125); |
| |
| /* SCIF0 */ |
| mstp_clrbits_le32(MSTPSR7, SMSTPCR7, SCIF0_MSTP721); |
| |
| /* ETHER */ |
| mstp_clrbits_le32(MSTPSR8, SMSTPCR8, ETHER_MSTP813); |
| |
| /* SDHI */ |
| mstp_clrbits_le32(MSTPSR3, SMSTPCR3, |
| SDHI0_MSTP314 | SDHI1_MSTP312 | SDHI2_MSTP311); |
| writel(SD_97500KHZ, SD1CKCR); |
| writel(SD_97500KHZ, SD2CKCR); |
| |
| return 0; |
| } |
| |
| #define PUPR5 0xE6060114 |
| #define PUPR5_ETH 0x3FFC0000 |
| #define PUPR5_ETH_MAGIC (1 << 27) |
| |
| int board_init(void) |
| { |
| /* adress of boot parameters */ |
| gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100; |
| |
| /* Init PFC controller */ |
| r8a7793_pinmux_init(); |
| |
| /* ETHER Enable */ |
| gpio_request(GPIO_FN_ETH_CRS_DV, NULL); |
| gpio_request(GPIO_FN_ETH_RX_ER, NULL); |
| gpio_request(GPIO_FN_ETH_RXD0, NULL); |
| gpio_request(GPIO_FN_ETH_RXD1, NULL); |
| gpio_request(GPIO_FN_ETH_LINK, NULL); |
| gpio_request(GPIO_FN_ETH_REFCLK, NULL); |
| gpio_request(GPIO_FN_ETH_MDIO, NULL); |
| gpio_request(GPIO_FN_ETH_TXD1, NULL); |
| gpio_request(GPIO_FN_ETH_TX_EN, NULL); |
| gpio_request(GPIO_FN_ETH_TXD0, NULL); |
| gpio_request(GPIO_FN_ETH_MDC, NULL); |
| gpio_request(GPIO_FN_IRQ0, NULL); |
| |
| mstp_clrbits_le32(PUPR5, PUPR5, PUPR5_ETH & ~PUPR5_ETH_MAGIC); |
| gpio_request(GPIO_GP_5_22, NULL); /* PHY_RST */ |
| mstp_clrbits_le32(PUPR5, PUPR5, PUPR5_ETH_MAGIC); |
| |
| gpio_direction_output(GPIO_GP_5_22, 0); |
| mdelay(20); |
| gpio_set_value(GPIO_GP_5_22, 1); |
| udelay(1); |
| |
| return 0; |
| } |
| |
| #define CXR24 0xEE7003C0 /* MAC address high register */ |
| #define CXR25 0xEE7003C8 /* MAC address low register */ |
| |
| int board_eth_init(bd_t *bis) |
| { |
| int ret = -ENODEV; |
| u32 val; |
| unsigned char enetaddr[6]; |
| |
| #ifdef CONFIG_SH_ETHER |
| ret = sh_eth_initialize(bis); |
| if (!eth_env_get_enetaddr("ethaddr", enetaddr)) |
| return ret; |
| |
| /* Set Mac address */ |
| val = enetaddr[0] << 24 | enetaddr[1] << 16 | |
| enetaddr[2] << 8 | enetaddr[3]; |
| writel(val, CXR24); |
| |
| val = enetaddr[4] << 8 | enetaddr[5]; |
| writel(val, CXR25); |
| #endif |
| |
| return ret; |
| } |
| |
| int board_mmc_init(bd_t *bis) |
| { |
| int ret = -ENODEV; |
| |
| #ifdef CONFIG_SH_SDHI |
| gpio_request(GPIO_FN_SD0_DATA0, NULL); |
| gpio_request(GPIO_FN_SD0_DATA1, NULL); |
| gpio_request(GPIO_FN_SD0_DATA2, NULL); |
| gpio_request(GPIO_FN_SD0_DATA3, NULL); |
| gpio_request(GPIO_FN_SD0_CLK, NULL); |
| gpio_request(GPIO_FN_SD0_CMD, NULL); |
| gpio_request(GPIO_FN_SD0_CD, NULL); |
| gpio_request(GPIO_FN_SD2_DATA0, NULL); |
| gpio_request(GPIO_FN_SD2_DATA1, NULL); |
| gpio_request(GPIO_FN_SD2_DATA2, NULL); |
| gpio_request(GPIO_FN_SD2_DATA3, NULL); |
| gpio_request(GPIO_FN_SD2_CLK, NULL); |
| gpio_request(GPIO_FN_SD2_CMD, NULL); |
| gpio_request(GPIO_FN_SD2_CD, NULL); |
| |
| /* SDHI 0 */ |
| gpio_request(GPIO_GP_7_17, NULL); |
| gpio_request(GPIO_GP_2_12, NULL); |
| gpio_direction_output(GPIO_GP_7_17, 1); /* power on */ |
| gpio_direction_output(GPIO_GP_2_12, 1); /* 1: 3.3V, 0: 1.8V */ |
| |
| ret = sh_sdhi_init(CONFIG_SYS_SH_SDHI0_BASE, 0, |
| SH_SDHI_QUIRK_16BIT_BUF); |
| if (ret) |
| return ret; |
| |
| /* SDHI 1 */ |
| gpio_request(GPIO_GP_7_18, NULL); |
| gpio_request(GPIO_GP_2_13, NULL); |
| gpio_direction_output(GPIO_GP_7_18, 1); /* power on */ |
| gpio_direction_output(GPIO_GP_2_13, 1); /* 1: 3.3V, 0: 1.8V */ |
| |
| ret = sh_sdhi_init(CONFIG_SYS_SH_SDHI1_BASE, 1, 0); |
| if (ret) |
| return ret; |
| |
| /* SDHI 2 */ |
| gpio_request(GPIO_GP_7_19, NULL); |
| gpio_request(GPIO_GP_2_26, NULL); |
| gpio_direction_output(GPIO_GP_7_19, 1); /* power on */ |
| gpio_direction_output(GPIO_GP_2_26, 1); /* 1: 3.3V, 0: 1.8V */ |
| |
| ret = sh_sdhi_init(CONFIG_SYS_SH_SDHI2_BASE, 2, 0); |
| #endif |
| return ret; |
| } |
| |
| int dram_init(void) |
| { |
| gd->ram_size = CONFIG_SYS_SDRAM_SIZE; |
| |
| return 0; |
| } |
| |
| const struct rmobile_sysinfo sysinfo = { |
| CONFIG_ARCH_RMOBILE_BOARD_STRING |
| }; |
| |
| void reset_cpu(ulong addr) |
| { |
| u8 val; |
| |
| i2c_set_bus_num(2); /* PowerIC connected to ch2 */ |
| i2c_read(CONFIG_SYS_I2C_POWERIC_ADDR, 0x13, 1, &val, 1); |
| val |= 0x02; |
| i2c_write(CONFIG_SYS_I2C_POWERIC_ADDR, 0x13, 1, &val, 1); |
| } |
| |
| static const struct sh_serial_platdata serial_platdata = { |
| .base = SCIF0_BASE, |
| .type = PORT_SCIF, |
| .clk = 14745600, |
| .clk_mode = EXT_CLK, |
| }; |
| |
| U_BOOT_DEVICE(gose_serials) = { |
| .name = "serial_sh", |
| .platdata = &serial_platdata, |
| }; |