| .. SPDX-License-Identifier: GPL-2.0+ |
| .. Copyright (C) 2019 Jagan Teki <jagan@amarulasolutions.com> |
| |
| ROCKCHIP |
| ======== |
| |
| About this |
| ---------- |
| |
| This document describes the information about Rockchip supported boards |
| and it's usage steps. |
| |
| Rockchip boards |
| --------------- |
| |
| Rockchip is SoC solutions provider for tablets & PCs, streaming media |
| TV boxes, AI audio & vision, IoT hardware. |
| |
| A wide range of Rockchip SoCs with associated boardsare supported in |
| mainline U-Boot. |
| |
| List of mainline supported rockchip boards: |
| |
| * rk3036 |
| - Rockchip Evb-RK3036 (evb-rk3036) |
| - Kylin (kylin_rk3036) |
| * rk3128 |
| - Rockchip Evb-RK3128 (evb-rk3128) |
| * rk3229 |
| - Rockchip Evb-RK3229 (evb-rk3229) |
| * rk3288 |
| - Rockchip Evb-RK3288 (evb-rk3288) |
| - Firefly-RK3288 (firefly-rk3288) |
| - MQmaker MiQi (miqi-rk3288) |
| - Phytec RK3288 PCM-947 (phycore-rk3288) |
| - PopMetal-RK3288 (popmetal-rk3288) |
| - Radxa Rock 2 Square (rock2) |
| - Tinker-RK3288 (tinker-rk3288) |
| - Google Jerry (chromebook_jerry) |
| - Google Mickey (chromebook_mickey) |
| - Google Minnie (chromebook_minnie) |
| - Google Speedy (chromebook_speedy) |
| - Amarula Vyasa-RK3288 (vyasa-rk3288) |
| * rk3308 |
| - Rockchip Evb-RK3308 (evb-rk3308) |
| - Roc-cc-RK3308 (roc-cc-rk3308) |
| * rk3328 |
| - Rockchip Evb-RK3328 (evb-rk3328) |
| - Pine64 Rock64 (rock64-rk3328) |
| - Firefly-RK3328 (roc-cc-rk3328) |
| - Radxa Rockpi E (rock-pi-e-rk3328) |
| * rk3368 |
| - GeekBox (geekbox) |
| - PX5 EVB (evb-px5) |
| - Rockchip Sheep (sheep-rk3368) |
| - Theobroma Systems RK3368-uQ7 SoM - Lion (lion-rk3368) |
| * rk3399 |
| - 96boards RK3399 Ficus (ficus-rk3399) |
| - 96boards Rock960 (rock960-rk3399) |
| - Firefly-RK3399 (firefly_rk3399) |
| - Firefly ROC-RK3399-PC |
| - FriendlyElec NanoPC-T4 (nanopc-t4-rk3399) |
| - FriendlyElec NanoPi M4 (nanopi-m4-rk3399) |
| - FriendlyARM NanoPi NEO4 (nanopi-neo4-rk3399) |
| - Google Bob (chromebook_bob) |
| - Khadas Edge (khadas-edge-rk3399) |
| - Khadas Edge-Captain (khadas-edge-captain-rk3399) |
| - Khadas Edge-V (hadas-edge-v-rk3399) |
| - Orange Pi RK3399 (orangepi-rk3399) |
| - Pine64 RockPro64 (rockpro64-rk3399) |
| - Radxa ROCK Pi 4 (rock-pi-4-rk3399) |
| - Rockchip Evb-RK3399 (evb_rk3399) |
| - Theobroma Systems RK3399-Q7 SoM - Puma (puma_rk3399) |
| * rv1108 |
| - Rockchip Evb-rv1108 (evb-rv1108) |
| - Elgin-R1 (elgin-rv1108) |
| * rv3188 |
| - Radxa Rock (rock) |
| |
| Building |
| -------- |
| |
| TF-A |
| ^^^^ |
| |
| TF-A would require to build for ARM64 Rockchip SoCs platforms. |
| |
| To build TF-A:: |
| |
| git clone https://github.com/ARM-software/arm-trusted-firmware.git |
| cd arm-trusted-firmware |
| make realclean |
| make CROSS_COMPILE=aarch64-linux-gnu- PLAT=rk3399 |
| |
| Specify the PLAT= with desired rockchip platform to build TF-A for. |
| |
| U-Boot |
| ^^^^^^ |
| |
| To build rk3328 boards:: |
| |
| export BL31=/path/to/arm-trusted-firmware/to/bl31.elf |
| make evb-rk3328_defconfig |
| make |
| |
| To build rk3288 boards:: |
| |
| make evb-rk3288_defconfig |
| make |
| |
| To build rk3368 boards:: |
| |
| export BL31=/path/to/arm-trusted-firmware/to/bl31.elf |
| make evb-px5_defconfig |
| make |
| |
| To build rk3399 boards:: |
| |
| export BL31=/path/to/arm-trusted-firmware/to/bl31.elf |
| make evb-rk3399_defconfig |
| make |
| |
| Flashing |
| -------- |
| |
| 1. Package the image with U-Boot TPL/SPL |
| ----------------------------------------- |
| |
| SD Card |
| ^^^^^^^ |
| |
| All rockchip platforms, except rk3128 (which doesn't use SPL) are now |
| supporting single boot image using binman and pad_cat. |
| |
| To write an image that boots from an SD card (assumed to be /dev/sda):: |
| |
| sudo dd if=u-boot-rockchip.bin of=/dev/sda seek=64 |
| sync |
| |
| eMMC |
| ^^^^ |
| |
| eMMC flash would probe on mmc0 in most of the rockchip platforms. |
| |
| Create GPT partition layout as defined in configurations:: |
| |
| mmc dev 0 |
| gpt write mmc 0 $partitions |
| |
| Connect the USB-OTG cable between host and target device. |
| |
| Launch fastboot at target:: |
| |
| fastboot 0 |
| |
| Upon successful gadget connection,host show the USB device like:: |
| |
| lsusb |
| Bus 001 Device 020: ID 2207:330c Fuzhou Rockchip Electronics Company RK3399 in Mask ROM mode |
| |
| Program the flash:: |
| |
| sudo fastboot -i 0x2207 flash loader1 idbloader.img |
| sudo fastboot -i 0x2207 flash loader2 u-boot.itb |
| |
| Note: for rockchip 32-bit platforms the U-Boot proper image |
| is u-boot-dtb.img |
| |
| SPI |
| ^^^ |
| |
| Generating idbloader for SPI boot would require to input a multi image |
| image format to mkimage tool instead of concerting (like for MMC boot). |
| |
| SPL-alone SPI boot image:: |
| |
| ./tools/mkimage -n rk3399 -T rkspi -d spl/u-boot-spl.bin idbloader.img |
| |
| TPL+SPL SPI boot image:: |
| |
| ./tools/mkimage -n rk3399 -T rkspi -d tpl/u-boot-tpl.bin:spl/u-boot-spl.bin idbloader.img |
| |
| Copy SPI boot images into SD card and boot from SD:: |
| |
| sf probe |
| load mmc 1:1 $kernel_addr_r idbloader.img |
| sf erase 0 +$filesize |
| sf write $kernel_addr_r 0 ${filesize} |
| load mmc 1:1 ${kernel_addr_r} u-boot.itb |
| sf erase 0x60000 +$filesize |
| sf write $kernel_addr_r 0x60000 ${filesize} |
| |
| 2. Package the image with Rockchip miniloader |
| --------------------------------------------- |
| |
| Image package with Rockchip miniloader requires robin [1]. |
| |
| Create idbloader.img |
| |
| .. code-block:: none |
| |
| cd u-boot |
| ./tools/mkimage -n px30 -T rksd -d rkbin/bin/rk33/px30_ddr_333MHz_v1.15.bin idbloader.img |
| cat rkbin/bin/rk33/px30_miniloader_v1.22.bin >> idbloader.img |
| sudo dd if=idbloader.img of=/dev/sda seek=64 |
| |
| Create trust.img |
| |
| .. code-block:: none |
| |
| cd rkbin |
| ./tools/trust_merger RKTRUST/PX30TRUST.ini |
| sudo dd if=trust.img of=/dev/sda seek=24576 |
| |
| Create uboot.img |
| |
| .. code-block:: none |
| |
| rbink/tools/loaderimage --pack --uboot u-boot-dtb.bin uboot.img 0x200000 |
| sudo dd if=uboot.img of=/dev/sda seek=16384 |
| |
| Note: |
| 1. 0x200000 is load address and it's an optional in some platforms. |
| 2. rkbin binaries are kept on updating, so would recommend to use the latest versions. |
| |
| TODO |
| ---- |
| |
| - Add rockchip idbloader image building |
| - Add rockchip TPL image building |
| - Document SPI flash boot |
| - Add missing SoC's with it boards list |
| |
| [1] https://github.com/rockchip-linux/rkbin |
| |
| .. Jagan Teki <jagan@amarulasolutions.com> |
| .. Wednesday 28 October 2020 06:47:26 PM IST |