blob: 1abfe889492b6bc9b3059edbace54186ffca7208 [file] [log] [blame]
/*
* Copyright (C) 2008-2013 Eric Jarrige <eric.jarrige@armadeus.org>
*
* based on the files by
* Sascha Hauer, Pengutronix
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <environment.h>
#include <jffs2/jffs2.h>
#include <nand.h>
#include <netdev.h>
#include <asm/io.h>
#include <asm/arch/imx-regs.h>
#include <asm/arch/gpio.h>
#include <asm/gpio.h>
#include <linux/errno.h>
#include "apf27.h"
#include "crc.h"
#include "fpga.h"
DECLARE_GLOBAL_DATA_PTR;
/*
* Fuse bank 1 row 8 is "reserved for future use" and therefore available for
* customer use. The APF27 board uses this fuse to store the board revision:
* 0: initial board revision
* 1: first revision - Presence of the second RAM chip on the board is blown in
* fuse bank 1 row 9 bit 0 - No hardware change
* N: to be defined
*/
static u32 get_board_rev(void)
{
struct iim_regs *iim = (struct iim_regs *)IMX_IIM_BASE;
return readl(&iim->bank[1].fuse_regs[8]);
}
/*
* Fuse bank 1 row 9 is "reserved for future use" and therefore available for
* customer use. The APF27 board revision 1 uses the bit 0 to permanently store
* the presence of the second RAM chip
* 0: AFP27 with 1 RAM of 64 MiB
* 1: AFP27 with 2 RAM chips of 64 MiB each (128MB)
*/
static int get_num_ram_bank(void)
{
struct iim_regs *iim = (struct iim_regs *)IMX_IIM_BASE;
int nr_dram_banks = 1;
if ((get_board_rev() > 0) && (CONFIG_NR_DRAM_BANKS > 1))
nr_dram_banks += readl(&iim->bank[1].fuse_regs[9]) & 0x01;
else
nr_dram_banks = CONFIG_NR_DRAM_POPULATED;
return nr_dram_banks;
}
static void apf27_port_init(int port, u32 gpio_dr, u32 ocr1, u32 ocr2,
u32 iconfa1, u32 iconfa2, u32 iconfb1, u32 iconfb2,
u32 icr1, u32 icr2, u32 imr, u32 gpio_dir, u32 gpr,
u32 puen, u32 gius)
{
struct gpio_port_regs *regs = (struct gpio_port_regs *)IMX_GPIO_BASE;
writel(gpio_dr, &regs->port[port].gpio_dr);
writel(ocr1, &regs->port[port].ocr1);
writel(ocr2, &regs->port[port].ocr2);
writel(iconfa1, &regs->port[port].iconfa1);
writel(iconfa2, &regs->port[port].iconfa2);
writel(iconfb1, &regs->port[port].iconfb1);
writel(iconfb2, &regs->port[port].iconfb2);
writel(icr1, &regs->port[port].icr1);
writel(icr2, &regs->port[port].icr2);
writel(imr, &regs->port[port].imr);
writel(gpio_dir, &regs->port[port].gpio_dir);
writel(gpr, &regs->port[port].gpr);
writel(puen, &regs->port[port].puen);
writel(gius, &regs->port[port].gius);
}
#define APF27_PORT_INIT(n) apf27_port_init(PORT##n, ACFG_DR_##n##_VAL, \
ACFG_OCR1_##n##_VAL, ACFG_OCR2_##n##_VAL, ACFG_ICFA1_##n##_VAL, \
ACFG_ICFA2_##n##_VAL, ACFG_ICFB1_##n##_VAL, ACFG_ICFB2_##n##_VAL, \
ACFG_ICR1_##n##_VAL, ACFG_ICR2_##n##_VAL, ACFG_IMR_##n##_VAL, \
ACFG_DDIR_##n##_VAL, ACFG_GPR_##n##_VAL, ACFG_PUEN_##n##_VAL, \
ACFG_GIUS_##n##_VAL)
static void apf27_iomux_init(void)
{
APF27_PORT_INIT(A);
APF27_PORT_INIT(B);
APF27_PORT_INIT(C);
APF27_PORT_INIT(D);
APF27_PORT_INIT(E);
APF27_PORT_INIT(F);
}
static int apf27_devices_init(void)
{
int i;
unsigned int mode[] = {
PC5_PF_I2C2_DATA,
PC6_PF_I2C2_CLK,
PD17_PF_I2C_DATA,
PD18_PF_I2C_CLK,
};
for (i = 0; i < ARRAY_SIZE(mode); i++)
imx_gpio_mode(mode[i]);
#ifdef CONFIG_MXC_UART
mx27_uart1_init_pins();
#endif
#ifdef CONFIG_FEC_MXC
mx27_fec_init_pins();
#endif
#ifdef CONFIG_MMC_MXC
mx27_sd2_init_pins();
imx_gpio_mode((GPIO_PORTF | GPIO_OUT | GPIO_PUEN | GPIO_GPIO | 16));
gpio_request(PC_PWRON, "pc_pwron");
gpio_set_value(PC_PWRON, 1);
#endif
return 0;
}
static void apf27_setup_csx(void)
{
struct weim_regs *weim = (struct weim_regs *)IMX_WEIM_BASE;
writel(ACFG_CS0U_VAL, &weim->cs0u);
writel(ACFG_CS0L_VAL, &weim->cs0l);
writel(ACFG_CS0A_VAL, &weim->cs0a);
writel(ACFG_CS1U_VAL, &weim->cs1u);
writel(ACFG_CS1L_VAL, &weim->cs1l);
writel(ACFG_CS1A_VAL, &weim->cs1a);
writel(ACFG_CS2U_VAL, &weim->cs2u);
writel(ACFG_CS2L_VAL, &weim->cs2l);
writel(ACFG_CS2A_VAL, &weim->cs2a);
writel(ACFG_CS3U_VAL, &weim->cs3u);
writel(ACFG_CS3L_VAL, &weim->cs3l);
writel(ACFG_CS3A_VAL, &weim->cs3a);
writel(ACFG_CS4U_VAL, &weim->cs4u);
writel(ACFG_CS4L_VAL, &weim->cs4l);
writel(ACFG_CS4A_VAL, &weim->cs4a);
writel(ACFG_CS5U_VAL, &weim->cs5u);
writel(ACFG_CS5L_VAL, &weim->cs5l);
writel(ACFG_CS5A_VAL, &weim->cs5a);
writel(ACFG_EIM_VAL, &weim->eim);
}
static void apf27_setup_port(void)
{
struct system_control_regs *system =
(struct system_control_regs *)IMX_SYSTEM_CTL_BASE;
writel(ACFG_FMCR_VAL, &system->fmcr);
}
int board_init(void)
{
gd->bd->bi_boot_params = PHYS_SDRAM_1 + 0x100;
apf27_setup_csx();
apf27_setup_port();
apf27_iomux_init();
apf27_devices_init();
#if defined(CONFIG_FPGA)
APF27_init_fpga();
#endif
return 0;
}
int dram_init(void)
{
gd->ram_size = get_ram_size((void *)PHYS_SDRAM_1, PHYS_SDRAM_1_SIZE);
if (get_num_ram_bank() > 1)
gd->ram_size += get_ram_size((void *)PHYS_SDRAM_2,
PHYS_SDRAM_2_SIZE);
return 0;
}
int dram_init_banksize(void)
{
gd->bd->bi_dram[0].start = PHYS_SDRAM_1;
gd->bd->bi_dram[0].size = get_ram_size((void *)PHYS_SDRAM_1,
PHYS_SDRAM_1_SIZE);
gd->bd->bi_dram[1].start = PHYS_SDRAM_2;
if (get_num_ram_bank() > 1)
gd->bd->bi_dram[1].size = get_ram_size((void *)PHYS_SDRAM_2,
PHYS_SDRAM_2_SIZE);
else
gd->bd->bi_dram[1].size = 0;
return 0;
}
ulong board_get_usable_ram_top(ulong total_size)
{
ulong ramtop;
if (get_num_ram_bank() > 1)
ramtop = PHYS_SDRAM_2 + get_ram_size((void *)PHYS_SDRAM_2,
PHYS_SDRAM_2_SIZE);
else
ramtop = PHYS_SDRAM_1 + get_ram_size((void *)PHYS_SDRAM_1,
PHYS_SDRAM_1_SIZE);
return ramtop;
}
int checkboard(void)
{
printf("Board: Armadeus APF27 revision %d\n", get_board_rev());
return 0;
}
#ifdef CONFIG_SPL_BUILD
inline void hang(void)
{
for (;;)
;
}
void board_init_f(ulong bootflag)
{
/*
* copy ourselves from where we are running to where we were
* linked at. Use ulong pointers as all addresses involved
* are 4-byte-aligned.
*/
ulong *start_ptr, *end_ptr, *link_ptr, *run_ptr, *dst;
asm volatile ("ldr %0, =_start" : "=r"(start_ptr));
asm volatile ("ldr %0, =_end" : "=r"(end_ptr));
asm volatile ("ldr %0, =board_init_f" : "=r"(link_ptr));
asm volatile ("adr %0, board_init_f" : "=r"(run_ptr));
for (dst = start_ptr; dst < end_ptr; dst++)
*dst = *(dst+(run_ptr-link_ptr));
/*
* branch to nand_boot's link-time address.
*/
asm volatile("ldr pc, =nand_boot");
}
#endif /* CONFIG_SPL_BUILD */