| x86 PCI DT details: |
| =================== |
| |
| Some options are available to affect how PCI operates on x86. |
| |
| Optional properties: |
| - u-boot,skip-auto-config-until-reloc : Don't set up PCI configuration until |
| after U-Boot has relocated. Normally if PCI is used before relocation, |
| this happens before relocation also. Some platforms set up static |
| configuration in TPL/SPL to reduce code size and boot time, since these |
| phases only know about a small subset of PCI devices. |
| |
| For PCI devices the following optional property is available: |
| |
| - pci,no-autoconfig : Don't automatically configure this PCI device at all. |
| This is used when the device is statically configured and must maintain |
| this same config throughout the boot process. An example is a serial |
| UART being used to debug PCI configuration, since reconfiguring it stops |
| the UART from working until the driver is re-probed, and this can cause |
| output to be lost. This should not generally be used in production code, |
| although it is often harmless. |
| |
| - u-boot,pci-pre-reloc : List of vendor/device IDs to bind before relocation, even |
| if they are not bridges. This is useful if the device is needed (e.g. a |
| UART). The format is 0xvvvvdddd where d is the device ID and v is the |
| vendor ID. |
| |
| Example: |
| |
| pci { |
| compatible = "pci-x86"; |
| #address-cells = <3>; |
| #size-cells = <2>; |
| bootph-all; |
| ranges = <0x02000000 0x0 0xc0000000 0xc0000000 0 0x10000000 |
| 0x42000000 0x0 0xb0000000 0xb0000000 0 0x10000000 |
| 0x01000000 0x0 0x1000 0x1000 0 0xefff>; |
| u-boot,skip-auto-config-until-reloc; |
| u-boot,pci-pre-reloc = < |
| PCI_VENDEV(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_APL_UART2)>; |
| |
| serial: serial@18,2 { |
| reg = <0x0200c210 0 0 0 0>; |
| bootph-all; |
| compatible = "intel,apl-ns16550"; |
| early-regs = <0xde000000 0x20>; |
| reg-shift = <2>; |
| clock-frequency = <1843200>; |
| current-speed = <115200>; |
| pci,no-autoconfig; |
| }; |
| }; |