| /* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */ |
| /* |
| * Copyright (c) 2015-2019, Arm Limited and Contributors. All rights reserved. |
| * Copyright (C) 2019-2020, Linaro Limited |
| */ |
| #ifndef _SCMI_PROTOCOLS_H |
| #define _SCMI_PROTOCOLS_H |
| |
| #include <linux/bitops.h> |
| #include <asm/types.h> |
| |
| /* |
| * Subset the SCMI protocols definition |
| * based on SCMI specification v2.0 (DEN0056B) |
| * https://developer.arm.com/docs/den0056/b |
| */ |
| |
| enum scmi_std_protocol { |
| SCMI_PROTOCOL_ID_BASE = 0x10, |
| SCMI_PROTOCOL_ID_POWER_DOMAIN = 0x11, |
| SCMI_PROTOCOL_ID_SYSTEM = 0x12, |
| SCMI_PROTOCOL_ID_PERF = 0x13, |
| SCMI_PROTOCOL_ID_CLOCK = 0x14, |
| SCMI_PROTOCOL_ID_SENSOR = 0x15, |
| SCMI_PROTOCOL_ID_RESET_DOMAIN = 0x16, |
| SCMI_PROTOCOL_ID_VOLTAGE_DOMAIN = 0x17, |
| }; |
| |
| enum scmi_status_code { |
| SCMI_SUCCESS = 0, |
| SCMI_NOT_SUPPORTED = -1, |
| SCMI_INVALID_PARAMETERS = -2, |
| SCMI_DENIED = -3, |
| SCMI_NOT_FOUND = -4, |
| SCMI_OUT_OF_RANGE = -5, |
| SCMI_BUSY = -6, |
| SCMI_COMMS_ERROR = -7, |
| SCMI_GENERIC_ERROR = -8, |
| SCMI_HARDWARE_ERROR = -9, |
| SCMI_PROTOCOL_ERROR = -10, |
| }; |
| |
| /* |
| * SCMI Clock Protocol |
| */ |
| |
| enum scmi_clock_message_id { |
| SCMI_CLOCK_RATE_SET = 0x5, |
| SCMI_CLOCK_RATE_GET = 0x6, |
| SCMI_CLOCK_CONFIG_SET = 0x7, |
| }; |
| |
| #define SCMI_CLK_RATE_ASYNC_NOTIFY BIT(0) |
| #define SCMI_CLK_RATE_ASYNC_NORESP (BIT(0) | BIT(1)) |
| #define SCMI_CLK_RATE_ROUND_DOWN 0 |
| #define SCMI_CLK_RATE_ROUND_UP BIT(2) |
| #define SCMI_CLK_RATE_ROUND_CLOSEST BIT(3) |
| |
| /** |
| * struct scmi_clk_state_in - Message payload for CLOCK_CONFIG_SET command |
| * @clock_id: SCMI clock ID |
| * @attributes: Attributes of the targets clock state |
| */ |
| struct scmi_clk_state_in { |
| u32 clock_id; |
| u32 attributes; |
| }; |
| |
| /** |
| * struct scmi_clk_state_out - Response payload for CLOCK_CONFIG_SET command |
| * @status: SCMI command status |
| */ |
| struct scmi_clk_state_out { |
| s32 status; |
| }; |
| |
| /** |
| * struct scmi_clk_state_in - Message payload for CLOCK_RATE_GET command |
| * @clock_id: SCMI clock ID |
| * @attributes: Attributes of the targets clock state |
| */ |
| struct scmi_clk_rate_get_in { |
| u32 clock_id; |
| }; |
| |
| /** |
| * struct scmi_clk_rate_get_out - Response payload for CLOCK_RATE_GET command |
| * @status: SCMI command status |
| * @rate_lsb: 32bit LSB of the clock rate in Hertz |
| * @rate_msb: 32bit MSB of the clock rate in Hertz |
| */ |
| struct scmi_clk_rate_get_out { |
| s32 status; |
| u32 rate_lsb; |
| u32 rate_msb; |
| }; |
| |
| /** |
| * struct scmi_clk_state_in - Message payload for CLOCK_RATE_SET command |
| * @clock_id: SCMI clock ID |
| * @flags: Flags for the clock rate set request |
| * @rate_lsb: 32bit LSB of the clock rate in Hertz |
| * @rate_msb: 32bit MSB of the clock rate in Hertz |
| */ |
| struct scmi_clk_rate_set_in { |
| u32 clock_id; |
| u32 flags; |
| u32 rate_lsb; |
| u32 rate_msb; |
| }; |
| |
| /** |
| * struct scmi_clk_rate_set_out - Response payload for CLOCK_RATE_SET command |
| * @status: SCMI command status |
| */ |
| struct scmi_clk_rate_set_out { |
| s32 status; |
| }; |
| |
| /* |
| * SCMI Reset Domain Protocol |
| */ |
| |
| enum scmi_reset_domain_message_id { |
| SCMI_RESET_DOMAIN_ATTRIBUTES = 0x3, |
| SCMI_RESET_DOMAIN_RESET = 0x4, |
| }; |
| |
| #define SCMI_RD_NAME_LEN 16 |
| |
| #define SCMI_RD_ATTRIBUTES_FLAG_ASYNC BIT(31) |
| #define SCMI_RD_ATTRIBUTES_FLAG_NOTIF BIT(30) |
| |
| #define SCMI_RD_RESET_FLAG_ASYNC BIT(2) |
| #define SCMI_RD_RESET_FLAG_ASSERT BIT(1) |
| #define SCMI_RD_RESET_FLAG_CYCLE BIT(0) |
| |
| /** |
| * struct scmi_rd_attr_in - Payload for RESET_DOMAIN_ATTRIBUTES message |
| * @domain_id: SCMI reset domain ID |
| */ |
| struct scmi_rd_attr_in { |
| u32 domain_id; |
| }; |
| |
| /** |
| * struct scmi_rd_attr_out - Payload for RESET_DOMAIN_ATTRIBUTES response |
| * @status: SCMI command status |
| * @attributes: Retrieved attributes of the reset domain |
| * @latency: Reset cycle max lantency |
| * @name: Reset domain name |
| */ |
| struct scmi_rd_attr_out { |
| s32 status; |
| u32 attributes; |
| u32 latency; |
| char name[SCMI_RD_NAME_LEN]; |
| }; |
| |
| /** |
| * struct scmi_rd_reset_in - Message payload for RESET command |
| * @domain_id: SCMI reset domain ID |
| * @flags: Flags for the reset request |
| * @reset_state: Reset target state |
| */ |
| struct scmi_rd_reset_in { |
| u32 domain_id; |
| u32 flags; |
| u32 reset_state; |
| }; |
| |
| /** |
| * struct scmi_rd_reset_out - Response payload for RESET command |
| * @status: SCMI command status |
| */ |
| struct scmi_rd_reset_out { |
| s32 status; |
| }; |
| |
| /* |
| * SCMI Voltage Domain Protocol |
| */ |
| |
| enum scmi_voltage_domain_message_id { |
| SCMI_VOLTAGE_DOMAIN_ATTRIBUTES = 0x3, |
| SCMI_VOLTAGE_DOMAIN_CONFIG_SET = 0x5, |
| SCMI_VOLTAGE_DOMAIN_CONFIG_GET = 0x6, |
| SCMI_VOLTAGE_DOMAIN_LEVEL_SET = 0x7, |
| SCMI_VOLTAGE_DOMAIN_LEVEL_GET = 0x8, |
| }; |
| |
| #define SCMI_VOLTD_NAME_LEN 16 |
| |
| #define SCMI_VOLTD_CONFIG_MASK GENMASK(3, 0) |
| #define SCMI_VOLTD_CONFIG_OFF 0 |
| #define SCMI_VOLTD_CONFIG_ON 0x7 |
| |
| /** |
| * struct scmi_voltd_attr_in - Payload for VOLTAGE_DOMAIN_ATTRIBUTES message |
| * @domain_id: SCMI voltage domain ID |
| */ |
| struct scmi_voltd_attr_in { |
| u32 domain_id; |
| }; |
| |
| /** |
| * struct scmi_voltd_attr_out - Payload for VOLTAGE_DOMAIN_ATTRIBUTES response |
| * @status: SCMI command status |
| * @attributes: Retrieved attributes of the voltage domain |
| * @name: Voltage domain name |
| */ |
| struct scmi_voltd_attr_out { |
| s32 status; |
| u32 attributes; |
| char name[SCMI_VOLTD_NAME_LEN]; |
| }; |
| |
| /** |
| * struct scmi_voltd_config_set_in - Message payload for VOLTAGE_CONFIG_SET cmd |
| * @domain_id: SCMI voltage domain ID |
| * @config: Configuration data of the voltage domain |
| */ |
| struct scmi_voltd_config_set_in { |
| u32 domain_id; |
| u32 config; |
| }; |
| |
| /** |
| * struct scmi_voltd_config_set_out - Response for VOLTAGE_CONFIG_SET command |
| * @status: SCMI command status |
| */ |
| struct scmi_voltd_config_set_out { |
| s32 status; |
| }; |
| |
| /** |
| * struct scmi_voltd_config_get_in - Message payload for VOLTAGE_CONFIG_GET cmd |
| * @domain_id: SCMI voltage domain ID |
| */ |
| struct scmi_voltd_config_get_in { |
| u32 domain_id; |
| }; |
| |
| /** |
| * struct scmi_voltd_config_get_out - Response for VOLTAGE_CONFIG_GET command |
| * @status: SCMI command status |
| * @config: Configuration data of the voltage domain |
| */ |
| struct scmi_voltd_config_get_out { |
| s32 status; |
| u32 config; |
| }; |
| |
| /** |
| * struct scmi_voltd_level_set_in - Message payload for VOLTAGE_LEVEL_SET cmd |
| * @domain_id: SCMI voltage domain ID |
| * @flags: Parameter flags for configuring target level |
| * @voltage_level: Target voltage level in microvolts (uV) |
| */ |
| struct scmi_voltd_level_set_in { |
| u32 domain_id; |
| u32 flags; |
| s32 voltage_level; |
| }; |
| |
| /** |
| * struct scmi_voltd_level_set_out - Response for VOLTAGE_LEVEL_SET command |
| * @status: SCMI command status |
| */ |
| struct scmi_voltd_level_set_out { |
| s32 status; |
| }; |
| |
| /** |
| * struct scmi_voltd_level_get_in - Message payload for VOLTAGE_LEVEL_GET cmd |
| * @domain_id: SCMI voltage domain ID |
| */ |
| struct scmi_voltd_level_get_in { |
| u32 domain_id; |
| }; |
| |
| /** |
| * struct scmi_voltd_level_get_out - Response for VOLTAGE_LEVEL_GET command |
| * @status: SCMI command status |
| * @voltage_level: Voltage level in microvolts (uV) |
| */ |
| struct scmi_voltd_level_get_out { |
| s32 status; |
| s32 voltage_level; |
| }; |
| |
| #endif /* _SCMI_PROTOCOLS_H */ |