| .. SPDX-License-Identifier: GPL-2.0+: |
| |
| wdt command |
| ============ |
| |
| Synopsis |
| -------- |
| |
| :: |
| |
| wdt list |
| wdt dev [<name>] |
| wdt start <timeout_ms> [flags] |
| wdt stop |
| wdt reset |
| wdt expirer [flags] |
| |
| Description |
| ----------- |
| |
| The wdt command is used to control watchdog timers. |
| |
| The 'wdt list' command shows a list of all watchdog devices. |
| |
| The 'wdt dev' command called without argument shows the current watchdog device. |
| The current device is set when passing the name of the device as argument. |
| |
| The 'wdt start' command starts the current watchdog timer. |
| |
| The 'wdt stop' command stops the current watchdog timer. |
| |
| The 'wdt reset' command resets the current watchdog timer without stopping it. |
| |
| The 'wdt expire' command let's the current watchdog timer expire immediately. |
| This will lead to a reset. |
| |
| name |
| name of the watchdog device |
| |
| timeout_ms |
| timeout interval in milliseconds |
| |
| flags |
| unsigned long value passed to the driver. The usage is driver specific. |
| The value is ignored by most drivers. |
| |
| Example |
| ------- |
| |
| :: |
| |
| => wdt dev |
| No watchdog timer device set! |
| => wdt list |
| watchdog@1c20ca0 (sunxi_wdt) |
| => wdt dev watchdog@1c20ca0 |
| => wdt dev |
| dev: watchdog@1c20ca0 |
| => wdt start 3000 |
| => wdt reset |
| => wdt stop |
| => wdt expire |
| |
| U-Boot SPL 2022.04-rc3 (Mar 25 2022 - 13:48:33 +0000) |
| |
| In the example above '(sunxi_wdt)' refers to the driver for the watchdog |
| device. |
| |
| Configuration |
| ------------- |
| |
| The command is only available if CONFIG_CMD_WDT=y. |
| |
| Return value |
| ------------ |
| |
| The return value $? is 0 if the command succeeds, 1 upon failure. |