| #include <common.h> |
| #include <dm.h> |
| #include <dm/pinctrl.h> |
| #include <asm/arch/gpio.h> |
| #include <asm/gpio.h> |
| #include <asm/io.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| #define MAX_PINS_ONE_IP 70 |
| #define MODE_BITS_MASK 3 |
| #define OSPEED_MASK 3 |
| #define PUPD_MASK 3 |
| #define OTYPE_MSK 1 |
| #define AFR_MASK 0xF |
| |
| static int stm32_gpio_config(struct gpio_desc *desc, |
| const struct stm32_gpio_ctl *ctl) |
| { |
| struct stm32_gpio_priv *priv = dev_get_priv(desc->dev); |
| struct stm32_gpio_regs *regs = priv->regs; |
| u32 index; |
| |
| if (!ctl || ctl->af > 15 || ctl->mode > 3 || ctl->otype > 1 || |
| ctl->pupd > 2 || ctl->speed > 3) |
| return -EINVAL; |
| |
| index = (desc->offset & 0x07) * 4; |
| clrsetbits_le32(®s->afr[desc->offset >> 3], AFR_MASK << index, |
| ctl->af << index); |
| |
| index = desc->offset * 2; |
| clrsetbits_le32(®s->moder, MODE_BITS_MASK << index, |
| ctl->mode << index); |
| clrsetbits_le32(®s->ospeedr, OSPEED_MASK << index, |
| ctl->speed << index); |
| clrsetbits_le32(®s->pupdr, PUPD_MASK << index, ctl->pupd << index); |
| |
| index = desc->offset; |
| clrsetbits_le32(®s->otyper, OTYPE_MSK << index, ctl->otype << index); |
| |
| return 0; |
| } |
| static int prep_gpio_dsc(struct stm32_gpio_dsc *gpio_dsc, u32 port_pin) |
| { |
| gpio_dsc->port = (port_pin & 0xF000) >> 12; |
| gpio_dsc->pin = (port_pin & 0x0F00) >> 8; |
| debug("%s: GPIO:port= %d, pin= %d\n", __func__, gpio_dsc->port, |
| gpio_dsc->pin); |
| |
| return 0; |
| } |
| |
| static int prep_gpio_ctl(struct stm32_gpio_ctl *gpio_ctl, u32 gpio_fn, int node) |
| { |
| gpio_fn &= 0x00FF; |
| gpio_ctl->af = 0; |
| |
| switch (gpio_fn) { |
| case 0: |
| gpio_ctl->mode = STM32_GPIO_MODE_IN; |
| break; |
| case 1 ... 16: |
| gpio_ctl->mode = STM32_GPIO_MODE_AF; |
| gpio_ctl->af = gpio_fn - 1; |
| break; |
| case 17: |
| gpio_ctl->mode = STM32_GPIO_MODE_AN; |
| break; |
| default: |
| gpio_ctl->mode = STM32_GPIO_MODE_OUT; |
| break; |
| } |
| |
| gpio_ctl->speed = fdtdec_get_int(gd->fdt_blob, node, "slew-rate", 0); |
| |
| if (fdtdec_get_bool(gd->fdt_blob, node, "drive-open-drain")) |
| gpio_ctl->otype = STM32_GPIO_OTYPE_OD; |
| else |
| gpio_ctl->otype = STM32_GPIO_OTYPE_PP; |
| |
| if (fdtdec_get_bool(gd->fdt_blob, node, "bias-pull-up")) |
| gpio_ctl->pupd = STM32_GPIO_PUPD_UP; |
| else if (fdtdec_get_bool(gd->fdt_blob, node, "bias-pull-down")) |
| gpio_ctl->pupd = STM32_GPIO_PUPD_DOWN; |
| else |
| gpio_ctl->pupd = STM32_GPIO_PUPD_NO; |
| |
| debug("%s: gpio fn= %d, slew-rate= %x, op type= %x, pull-upd is = %x\n", |
| __func__, gpio_fn, gpio_ctl->speed, gpio_ctl->otype, |
| gpio_ctl->pupd); |
| |
| return 0; |
| } |
| |
| static int stm32_pinctrl_config(int offset) |
| { |
| u32 pin_mux[MAX_PINS_ONE_IP]; |
| int rv, len; |
| |
| /* |
| * check for "pinmux" property in each subnode (e.g. pins1 and pins2 for |
| * usart1) of pin controller phandle "pinctrl-0" |
| * */ |
| fdt_for_each_subnode(offset, gd->fdt_blob, offset) { |
| struct stm32_gpio_dsc gpio_dsc; |
| struct stm32_gpio_ctl gpio_ctl; |
| int i; |
| |
| len = fdtdec_get_int_array_count(gd->fdt_blob, offset, |
| "pinmux", pin_mux, |
| ARRAY_SIZE(pin_mux)); |
| debug("%s: no of pinmux entries= %d\n", __func__, len); |
| if (len < 0) |
| return -EINVAL; |
| for (i = 0; i < len; i++) { |
| struct gpio_desc desc; |
| debug("%s: pinmux = %x\n", __func__, *(pin_mux + i)); |
| prep_gpio_dsc(&gpio_dsc, *(pin_mux + i)); |
| prep_gpio_ctl(&gpio_ctl, *(pin_mux + i), offset); |
| rv = uclass_get_device_by_seq(UCLASS_GPIO, |
| gpio_dsc.port, &desc.dev); |
| if (rv) |
| return rv; |
| desc.offset = gpio_dsc.pin; |
| rv = stm32_gpio_config(&desc, &gpio_ctl); |
| debug("%s: rv = %d\n\n", __func__, rv); |
| if (rv) |
| return rv; |
| } |
| } |
| |
| return 0; |
| } |
| |
| #if CONFIG_IS_ENABLED(PINCTRL_FULL) |
| static int stm32_pinctrl_set_state(struct udevice *dev, struct udevice *config) |
| { |
| return stm32_pinctrl_config(dev_of_offset(config)); |
| } |
| #else /* PINCTRL_FULL */ |
| static int stm32_pinctrl_set_state_simple(struct udevice *dev, |
| struct udevice *periph) |
| { |
| const void *fdt = gd->fdt_blob; |
| const fdt32_t *list; |
| uint32_t phandle; |
| int config_node; |
| int size, i, ret; |
| |
| list = fdt_getprop(fdt, dev_of_offset(periph), "pinctrl-0", &size); |
| if (!list) |
| return -EINVAL; |
| |
| debug("%s: periph->name = %s\n", __func__, periph->name); |
| |
| size /= sizeof(*list); |
| for (i = 0; i < size; i++) { |
| phandle = fdt32_to_cpu(*list++); |
| |
| config_node = fdt_node_offset_by_phandle(fdt, phandle); |
| if (config_node < 0) { |
| pr_err("prop pinctrl-0 index %d invalid phandle\n", i); |
| return -EINVAL; |
| } |
| |
| ret = stm32_pinctrl_config(config_node); |
| if (ret) |
| return ret; |
| } |
| |
| return 0; |
| } |
| #endif /* PINCTRL_FULL */ |
| |
| static struct pinctrl_ops stm32_pinctrl_ops = { |
| #if CONFIG_IS_ENABLED(PINCTRL_FULL) |
| .set_state = stm32_pinctrl_set_state, |
| #else /* PINCTRL_FULL */ |
| .set_state_simple = stm32_pinctrl_set_state_simple, |
| #endif /* PINCTRL_FULL */ |
| }; |
| |
| static const struct udevice_id stm32_pinctrl_ids[] = { |
| { .compatible = "st,stm32f746-pinctrl" }, |
| { .compatible = "st,stm32h743-pinctrl" }, |
| { } |
| }; |
| |
| U_BOOT_DRIVER(pinctrl_stm32) = { |
| .name = "pinctrl_stm32", |
| .id = UCLASS_PINCTRL, |
| .of_match = stm32_pinctrl_ids, |
| .ops = &stm32_pinctrl_ops, |
| .bind = dm_scan_fdt_dev, |
| }; |