| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Cirrus Logic CS8900A Ethernet |
| * |
| * (C) 2009 Ben Warren , biggerbadderben@gmail.com |
| * Converted to use CONFIG_NET_MULTI API |
| * |
| * (C) 2003 Wolfgang Denk, wd@denx.de |
| * Extension to synchronize ethaddr environment variable |
| * against value in EEPROM |
| * |
| * (C) Copyright 2002 |
| * Sysgo Real-Time Solutions, GmbH <www.elinos.com> |
| * Marius Groeger <mgroeger@sysgo.de> |
| * |
| * Copyright (C) 1999 Ben Williamson <benw@pobox.com> |
| * |
| * This program is loaded into SRAM in bootstrap mode, where it waits |
| * for commands on UART1 to read and write memory, jump to code etc. |
| * A design goal for this program is to be entirely independent of the |
| * target board. Anything with a CL-PS7111 or EP7211 should be able to run |
| * this code in bootstrap mode. All the board specifics can be handled on |
| * the host. |
| */ |
| |
| #include <common.h> |
| #include <command.h> |
| #include <asm/io.h> |
| #include <net.h> |
| #include <malloc.h> |
| #include "cs8900.h" |
| |
| #undef DEBUG |
| |
| /* packet page register access functions */ |
| |
| #ifdef CONFIG_CS8900_BUS32 |
| |
| #define REG_WRITE(v, a) writel((v),(a)) |
| #define REG_READ(a) readl((a)) |
| |
| /* we don't need 16 bit initialisation on 32 bit bus */ |
| #define get_reg_init_bus(r,d) get_reg((r),(d)) |
| |
| #else |
| |
| #define REG_WRITE(v, a) writew((v),(a)) |
| #define REG_READ(a) readw((a)) |
| |
| static u16 get_reg_init_bus(struct eth_device *dev, int regno) |
| { |
| /* force 16 bit busmode */ |
| struct cs8900_priv *priv = (struct cs8900_priv *)(dev->priv); |
| uint8_t volatile * const iob = (uint8_t volatile * const)dev->iobase; |
| |
| readb(iob); |
| readb(iob + 1); |
| readb(iob); |
| readb(iob + 1); |
| readb(iob); |
| |
| REG_WRITE(regno, &priv->regs->pptr); |
| return REG_READ(&priv->regs->pdata); |
| } |
| #endif |
| |
| static u16 get_reg(struct eth_device *dev, int regno) |
| { |
| struct cs8900_priv *priv = (struct cs8900_priv *)(dev->priv); |
| REG_WRITE(regno, &priv->regs->pptr); |
| return REG_READ(&priv->regs->pdata); |
| } |
| |
| |
| static void put_reg(struct eth_device *dev, int regno, u16 val) |
| { |
| struct cs8900_priv *priv = (struct cs8900_priv *)(dev->priv); |
| REG_WRITE(regno, &priv->regs->pptr); |
| REG_WRITE(val, &priv->regs->pdata); |
| } |
| |
| static void cs8900_reset(struct eth_device *dev) |
| { |
| int tmo; |
| u16 us; |
| |
| /* reset NIC */ |
| put_reg(dev, PP_SelfCTL, get_reg(dev, PP_SelfCTL) | PP_SelfCTL_Reset); |
| |
| /* wait for 200ms */ |
| udelay(200000); |
| /* Wait until the chip is reset */ |
| |
| tmo = get_timer(0) + 1 * CONFIG_SYS_HZ; |
| while ((((us = get_reg_init_bus(dev, PP_SelfSTAT)) & |
| PP_SelfSTAT_InitD) == 0) && tmo < get_timer(0)) |
| /*NOP*/; |
| } |
| |
| static void cs8900_reginit(struct eth_device *dev) |
| { |
| /* receive only error free packets addressed to this card */ |
| put_reg(dev, PP_RxCTL, |
| PP_RxCTL_IA | PP_RxCTL_Broadcast | PP_RxCTL_RxOK); |
| /* do not generate any interrupts on receive operations */ |
| put_reg(dev, PP_RxCFG, 0); |
| /* do not generate any interrupts on transmit operations */ |
| put_reg(dev, PP_TxCFG, 0); |
| /* do not generate any interrupts on buffer operations */ |
| put_reg(dev, PP_BufCFG, 0); |
| /* enable transmitter/receiver mode */ |
| put_reg(dev, PP_LineCTL, PP_LineCTL_Rx | PP_LineCTL_Tx); |
| } |
| |
| void cs8900_get_enetaddr(struct eth_device *dev) |
| { |
| int i; |
| |
| /* verify chip id */ |
| if (get_reg_init_bus(dev, PP_ChipID) != 0x630e) |
| return; |
| cs8900_reset(dev); |
| if ((get_reg(dev, PP_SelfSTAT) & |
| (PP_SelfSTAT_EEPROM | PP_SelfSTAT_EEPROM_OK)) == |
| (PP_SelfSTAT_EEPROM | PP_SelfSTAT_EEPROM_OK)) { |
| |
| /* Load the MAC from EEPROM */ |
| for (i = 0; i < 3; i++) { |
| u32 Addr; |
| |
| Addr = get_reg(dev, PP_IA + i * 2); |
| dev->enetaddr[i * 2] = Addr & 0xFF; |
| dev->enetaddr[i * 2 + 1] = Addr >> 8; |
| } |
| } |
| } |
| |
| void cs8900_halt(struct eth_device *dev) |
| { |
| /* disable transmitter/receiver mode */ |
| put_reg(dev, PP_LineCTL, 0); |
| |
| /* "shutdown" to show ChipID or kernel wouldn't find he cs8900 ... */ |
| get_reg_init_bus(dev, PP_ChipID); |
| } |
| |
| static int cs8900_init(struct eth_device *dev, bd_t * bd) |
| { |
| uchar *enetaddr = dev->enetaddr; |
| u16 id; |
| |
| /* verify chip id */ |
| id = get_reg_init_bus(dev, PP_ChipID); |
| if (id != 0x630e) { |
| printf ("CS8900 Ethernet chip not found: " |
| "ID=0x%04x instead 0x%04x\n", id, 0x630e); |
| return 1; |
| } |
| |
| cs8900_reset (dev); |
| /* set the ethernet address */ |
| put_reg(dev, PP_IA + 0, enetaddr[0] | (enetaddr[1] << 8)); |
| put_reg(dev, PP_IA + 2, enetaddr[2] | (enetaddr[3] << 8)); |
| put_reg(dev, PP_IA + 4, enetaddr[4] | (enetaddr[5] << 8)); |
| |
| cs8900_reginit(dev); |
| return 0; |
| } |
| |
| /* Get a data block via Ethernet */ |
| static int cs8900_recv(struct eth_device *dev) |
| { |
| int i; |
| u16 rxlen; |
| u16 *addr; |
| u16 status; |
| |
| struct cs8900_priv *priv = (struct cs8900_priv *)(dev->priv); |
| |
| status = get_reg(dev, PP_RER); |
| |
| if ((status & PP_RER_RxOK) == 0) |
| return 0; |
| |
| status = REG_READ(&priv->regs->rtdata); |
| rxlen = REG_READ(&priv->regs->rtdata); |
| |
| if (rxlen > PKTSIZE_ALIGN + PKTALIGN) |
| debug("packet too big!\n"); |
| for (addr = (u16 *)net_rx_packets[0], i = rxlen >> 1; i > 0; i--) |
| *addr++ = REG_READ(&priv->regs->rtdata); |
| if (rxlen & 1) |
| *addr++ = REG_READ(&priv->regs->rtdata); |
| |
| /* Pass the packet up to the protocol layers. */ |
| net_process_received_packet(net_rx_packets[0], rxlen); |
| return rxlen; |
| } |
| |
| /* Send a data block via Ethernet. */ |
| static int cs8900_send(struct eth_device *dev, void *packet, int length) |
| { |
| volatile u16 *addr; |
| int tmo; |
| u16 s; |
| struct cs8900_priv *priv = (struct cs8900_priv *)(dev->priv); |
| |
| retry: |
| /* initiate a transmit sequence */ |
| REG_WRITE(PP_TxCmd_TxStart_Full, &priv->regs->txcmd); |
| REG_WRITE(length, &priv->regs->txlen); |
| |
| /* Test to see if the chip has allocated memory for the packet */ |
| if ((get_reg(dev, PP_BusSTAT) & PP_BusSTAT_TxRDY) == 0) { |
| /* Oops... this should not happen! */ |
| debug("cs: unable to send packet; retrying...\n"); |
| for (tmo = get_timer(0) + 5 * CONFIG_SYS_HZ; |
| get_timer(0) < tmo;) |
| /*NOP*/; |
| cs8900_reset(dev); |
| cs8900_reginit(dev); |
| goto retry; |
| } |
| |
| /* Write the contents of the packet */ |
| /* assume even number of bytes */ |
| for (addr = packet; length > 0; length -= 2) |
| REG_WRITE(*addr++, &priv->regs->rtdata); |
| |
| /* wait for transfer to succeed */ |
| tmo = get_timer(0) + 5 * CONFIG_SYS_HZ; |
| while ((s = get_reg(dev, PP_TER) & ~0x1F) == 0) { |
| if (get_timer(0) >= tmo) |
| break; |
| } |
| |
| /* nothing */ ; |
| if((s & (PP_TER_CRS | PP_TER_TxOK)) != PP_TER_TxOK) { |
| debug("\ntransmission error %#x\n", s); |
| } |
| |
| return 0; |
| } |
| |
| static void cs8900_e2prom_ready(struct eth_device *dev) |
| { |
| while (get_reg(dev, PP_SelfSTAT) & SI_BUSY) |
| ; |
| } |
| |
| /***********************************************************/ |
| /* read a 16-bit word out of the EEPROM */ |
| /***********************************************************/ |
| |
| int cs8900_e2prom_read(struct eth_device *dev, |
| u8 addr, u16 *value) |
| { |
| cs8900_e2prom_ready(dev); |
| put_reg(dev, PP_EECMD, EEPROM_READ_CMD | addr); |
| cs8900_e2prom_ready(dev); |
| *value = get_reg(dev, PP_EEData); |
| |
| return 0; |
| } |
| |
| |
| /***********************************************************/ |
| /* write a 16-bit word into the EEPROM */ |
| /***********************************************************/ |
| |
| int cs8900_e2prom_write(struct eth_device *dev, u8 addr, u16 value) |
| { |
| cs8900_e2prom_ready(dev); |
| put_reg(dev, PP_EECMD, EEPROM_WRITE_EN); |
| cs8900_e2prom_ready(dev); |
| put_reg(dev, PP_EEData, value); |
| put_reg(dev, PP_EECMD, EEPROM_WRITE_CMD | addr); |
| cs8900_e2prom_ready(dev); |
| put_reg(dev, PP_EECMD, EEPROM_WRITE_DIS); |
| cs8900_e2prom_ready(dev); |
| |
| return 0; |
| } |
| |
| int cs8900_initialize(u8 dev_num, int base_addr) |
| { |
| struct eth_device *dev; |
| struct cs8900_priv *priv; |
| |
| dev = malloc(sizeof(*dev)); |
| if (!dev) { |
| return 0; |
| } |
| memset(dev, 0, sizeof(*dev)); |
| |
| priv = malloc(sizeof(*priv)); |
| if (!priv) { |
| free(dev); |
| return 0; |
| } |
| memset(priv, 0, sizeof(*priv)); |
| priv->regs = (struct cs8900_regs *)base_addr; |
| |
| dev->iobase = base_addr; |
| dev->priv = priv; |
| dev->init = cs8900_init; |
| dev->halt = cs8900_halt; |
| dev->send = cs8900_send; |
| dev->recv = cs8900_recv; |
| |
| /* Load MAC address from EEPROM */ |
| cs8900_get_enetaddr(dev); |
| |
| sprintf(dev->name, "%s-%hu", CS8900_DRIVERNAME, dev_num); |
| |
| eth_register(dev); |
| return 0; |
| } |