| /* |
| * (C) Copyright 2013 Siemens Schweiz AG |
| * (C) Heiko Schocher, DENX Software Engineering, hs@denx.de. |
| * |
| * Based on: |
| * U-Boot file:/include/configs/am335x_evm.h |
| * |
| * Copyright (C) 2011 Texas Instruments Incorporated - http://www.ti.com/ |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #ifndef __CONFIG_THUBAN_H |
| #define __CONFIG_THUBAN_H |
| |
| #include "siemens-am33x-common.h" |
| |
| #define CONFIG_SYS_MPUCLK 300 |
| #define DDR_PLL_FREQ 303 |
| #undef CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC |
| |
| #define BOARD_DFU_BUTTON_GPIO 27 /* Use as default */ |
| #define GPIO_LAN9303_NRST 88 /* GPIO2_24 = gpio88 */ |
| |
| #define CONFIG_ENV_SETTINGS_BUTTONS_AND_LEDS \ |
| "button_dfu0=27\0" \ |
| "led0=103,1,0\0" \ |
| "led1=64,0,1\0" |
| |
| #undef CONFIG_DOS_PARTITION |
| |
| #define CONFIG_BOARD_LATE_INIT |
| |
| /* Physical Memory Map */ |
| #define CONFIG_MAX_RAM_BANK_SIZE (1024 << 20) /* 1GB */ |
| |
| /* I2C Configuration */ |
| #define CONFIG_SYS_I2C_SPEED 100000 |
| |
| #define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 |
| #define EEPROM_ADDR_DDR3 0x90 |
| #define EEPROM_ADDR_CHIP 0x120 |
| |
| #define CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS 0x300 |
| |
| #undef CONFIG_MII |
| #undef CONFIG_PHY_GIGE |
| #define CONFIG_PHY_SMSC |
| |
| #define CONFIG_FACTORYSET |
| |
| /* Watchdog */ |
| #define CONFIG_OMAP_WATCHDOG |
| |
| /* Define own nand partitions */ |
| #define CONFIG_ENV_OFFSET_REDUND 0x2E0000 |
| #define CONFIG_ENV_SIZE_REDUND 0x2000 |
| #define CONFIG_ENV_RANGE (4 * CONFIG_SYS_ENV_SECT_SIZE) |
| |
| #define MTDPARTS_DEFAULT MTDPARTS_DEFAULT_V2 |
| |
| #ifndef CONFIG_SPL_BUILD |
| |
| /* Default env settings */ |
| #define CONFIG_EXTRA_ENV_SETTINGS \ |
| "hostname=thuban\0" \ |
| "ubi_off=2048\0"\ |
| "nand_img_size=0x400000\0" \ |
| "optargs=\0" \ |
| "preboot=draco_led 0\0" \ |
| CONFIG_ENV_SETTINGS_BUTTONS_AND_LEDS \ |
| CONFIG_ENV_SETTINGS_V2 \ |
| CONFIG_ENV_SETTINGS_NAND_V2 |
| |
| #ifndef CONFIG_RESTORE_FLASH |
| /* set to negative value for no autoboot */ |
| |
| #define CONFIG_BOOTCOMMAND \ |
| "if dfubutton; then " \ |
| "run dfu_start; " \ |
| "reset; " \ |
| "fi;" \ |
| "run nand_boot;" \ |
| "run nand_boot_backup;" \ |
| "reset;" |
| |
| #else |
| |
| #define CONFIG_BOOTCOMMAND \ |
| "setenv autoload no; " \ |
| "dhcp; " \ |
| "if tftp 80000000 debrick.scr; then " \ |
| "source 80000000; " \ |
| "fi" |
| #endif |
| #endif /* CONFIG_SPL_BUILD */ |
| #endif /* ! __CONFIG_THUBAN_H */ |