blob: 1759d25f3a39bad372de02b0f41dbeb7af5091b1 [file] [log] [blame]
/* SPDX-License-Identifier: GPL-2.0+ */
/*
* Copyright 2019-2020 NXP
*/
#ifndef __LS1046AFRWY_H__
#define __LS1046AFRWY_H__
#include "ls1046a_common.h"
#define CFG_SYS_UBOOT_BASE 0x40100000
/*
* NAND Flash Definitions
*/
#define CFG_SYS_NAND_BASE 0x7e800000
#define CFG_SYS_NAND_BASE_PHYS CFG_SYS_NAND_BASE
#define CFG_SYS_NAND_CSPR_EXT (0x0)
#define CFG_SYS_NAND_CSPR (CSPR_PHYS_ADDR(CFG_SYS_NAND_BASE_PHYS) \
| CSPR_PORT_SIZE_8 \
| CSPR_MSEL_NAND \
| CSPR_V)
#define CFG_SYS_NAND_AMASK IFC_AMASK(64 * 1024)
#define CFG_SYS_NAND_CSOR (CSOR_NAND_ECC_ENC_EN /* ECC on encode */ \
| CSOR_NAND_ECC_DEC_EN /* ECC on decode */ \
| CSOR_NAND_ECC_MODE_4 /* 4-bit ECC */ \
| CSOR_NAND_RAL_3 /* RAL = 3 Bytes */ \
| CSOR_NAND_PGS_2K /* Page Size = 2K */ \
| CSOR_NAND_SPRZ_128 /* Spare size = 128 */ \
| CSOR_NAND_PB(64)) /* 64 Pages Per Block */
#define CFG_SYS_NAND_FTIM0 (FTIM0_NAND_TCCST(0x7) | \
FTIM0_NAND_TWP(0x18) | \
FTIM0_NAND_TWCHT(0x7) | \
FTIM0_NAND_TWH(0xa))
#define CFG_SYS_NAND_FTIM1 (FTIM1_NAND_TADLE(0x32) | \
FTIM1_NAND_TWBE(0x39) | \
FTIM1_NAND_TRR(0xe) | \
FTIM1_NAND_TRP(0x18))
#define CFG_SYS_NAND_FTIM2 (FTIM2_NAND_TRAD(0xf) | \
FTIM2_NAND_TREH(0xa) | \
FTIM2_NAND_TWHRE(0x1e))
#define CFG_SYS_NAND_FTIM3 0x0
#define CFG_SYS_NAND_BASE_LIST { CFG_SYS_NAND_BASE }
#define CONFIG_MTD_NAND_VERIFY_WRITE
/* IFC Timing Params */
#define CFG_SYS_CSPR0_EXT CFG_SYS_NAND_CSPR_EXT
#define CFG_SYS_CSPR0 CFG_SYS_NAND_CSPR
#define CFG_SYS_AMASK0 CFG_SYS_NAND_AMASK
#define CFG_SYS_CSOR0 CFG_SYS_NAND_CSOR
#define CFG_SYS_CS0_FTIM0 CFG_SYS_NAND_FTIM0
#define CFG_SYS_CS0_FTIM1 CFG_SYS_NAND_FTIM1
#define CFG_SYS_CS0_FTIM2 CFG_SYS_NAND_FTIM2
#define CFG_SYS_CS0_FTIM3 CFG_SYS_NAND_FTIM3
/* EEPROM */
#define I2C_RETIMER_ADDR 0x18
/* I2C bus multiplexer */
#define I2C_MUX_PCA_ADDR_PRI 0x77 /* Primary Mux*/
#define I2C_MUX_CH_DEFAULT 0x1 /* Channel 0*/
#define I2C_MUX_CH_RTC 0x1 /* Channel 0*/
/* RTC */
#define CFG_SYS_I2C_RTC_ADDR 0x51 /* Channel 0 I2C bus 0*/
#define CFG_SYS_RTC_BUS_NUM 0
/*
* Environment
*/
#define CFG_SYS_FSL_QSPI_BASE 0x40000000
#undef BOOT_TARGET_DEVICES
#define BOOT_TARGET_DEVICES(func) \
func(MMC, mmc, 0) \
func(USB, usb, 0) \
func(DHCP, dhcp, na)
/* FMan */
#ifdef CONFIG_SYS_DPAA_FMAN
#define QSGMII_PORT1_PHY_ADDR 0x1c
#define QSGMII_PORT2_PHY_ADDR 0x1d
#define QSGMII_PORT3_PHY_ADDR 0x1e
#define QSGMII_PORT4_PHY_ADDR 0x1f
#define FDT_SEQ_MACADDR_FROM_ENV
#endif
#define QSPI_NOR_BOOTCOMMAND "run distro_bootcmd; run qspi_bootcmd; " \
"env exists secureboot && esbc_halt;;"
#define SD_BOOTCOMMAND "run distro_bootcmd;run sd_bootcmd; " \
"env exists secureboot && esbc_halt;"
#include <asm/fsl_secure_boot.h>
#endif /* __LS1046AFRWY_H__ */