| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright (C) 2012-2017 Altera Corporation <www.altera.com> |
| */ |
| |
| #include <common.h> |
| #include <asm/io.h> |
| #include <errno.h> |
| #include <fdtdec.h> |
| #include <linux/libfdt.h> |
| #include <altera.h> |
| #include <miiphy.h> |
| #include <netdev.h> |
| #include <watchdog.h> |
| #include <asm/arch/misc.h> |
| #include <asm/arch/reset_manager.h> |
| #include <asm/arch/scan_manager.h> |
| #include <asm/arch/system_manager.h> |
| #include <asm/arch/nic301.h> |
| #include <asm/arch/scu.h> |
| #include <asm/pl310.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| #ifdef CONFIG_SYS_L2_PL310 |
| static const struct pl310_regs *const pl310 = |
| (struct pl310_regs *)CONFIG_SYS_PL310_BASE; |
| #endif |
| |
| struct bsel bsel_str[] = { |
| { "rsvd", "Reserved", }, |
| { "fpga", "FPGA (HPS2FPGA Bridge)", }, |
| { "nand", "NAND Flash (1.8V)", }, |
| { "nand", "NAND Flash (3.0V)", }, |
| { "sd", "SD/MMC External Transceiver (1.8V)", }, |
| { "sd", "SD/MMC Internal Transceiver (3.0V)", }, |
| { "qspi", "QSPI Flash (1.8V)", }, |
| { "qspi", "QSPI Flash (3.0V)", }, |
| }; |
| |
| int dram_init(void) |
| { |
| if (fdtdec_setup_mem_size_base() != 0) |
| return -EINVAL; |
| |
| return 0; |
| } |
| |
| void enable_caches(void) |
| { |
| #ifndef CONFIG_SYS_ICACHE_OFF |
| icache_enable(); |
| #endif |
| #ifndef CONFIG_SYS_DCACHE_OFF |
| dcache_enable(); |
| #endif |
| } |
| |
| #ifdef CONFIG_SYS_L2_PL310 |
| void v7_outer_cache_enable(void) |
| { |
| /* Disable the L2 cache */ |
| clrbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN); |
| |
| /* enable BRESP, instruction and data prefetch, full line of zeroes */ |
| setbits_le32(&pl310->pl310_aux_ctrl, |
| L310_AUX_CTRL_DATA_PREFETCH_MASK | |
| L310_AUX_CTRL_INST_PREFETCH_MASK | |
| L310_SHARED_ATT_OVERRIDE_ENABLE); |
| |
| /* Enable the L2 cache */ |
| setbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN); |
| } |
| |
| void v7_outer_cache_disable(void) |
| { |
| /* Disable the L2 cache */ |
| clrbits_le32(&pl310->pl310_ctrl, L2X0_CTRL_EN); |
| } |
| #endif |
| |
| #if defined(CONFIG_SYS_CONSOLE_IS_IN_ENV) && \ |
| defined(CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE) |
| int overwrite_console(void) |
| { |
| return 0; |
| } |
| #endif |
| |
| #ifdef CONFIG_FPGA |
| /* add device descriptor to FPGA device table */ |
| void socfpga_fpga_add(void *fpga_desc) |
| { |
| fpga_init(); |
| fpga_add(fpga_altera, fpga_desc); |
| } |
| #endif |
| |
| int arch_cpu_init(void) |
| { |
| #ifdef CONFIG_HW_WATCHDOG |
| /* |
| * In case the watchdog is enabled, make sure to (re-)configure it |
| * so that the defined timeout is valid. Otherwise the SPL (Perloader) |
| * timeout value is still active which might too short for Linux |
| * booting. |
| */ |
| hw_watchdog_init(); |
| #else |
| /* |
| * If the HW watchdog is NOT enabled, make sure it is not running, |
| * for example because it was enabled in the preloader. This might |
| * trigger a watchdog-triggered reboot of Linux kernel later. |
| * Toggle watchdog reset, so watchdog in not running state. |
| */ |
| socfpga_per_reset(SOCFPGA_RESET(L4WD0), 1); |
| socfpga_per_reset(SOCFPGA_RESET(L4WD0), 0); |
| #endif |
| |
| return 0; |
| } |
| |
| #ifdef CONFIG_ETH_DESIGNWARE |
| static int dwmac_phymode_to_modereg(const char *phymode, u32 *modereg) |
| { |
| if (!phymode) |
| return -EINVAL; |
| |
| if (!strcmp(phymode, "mii") || !strcmp(phymode, "gmii")) { |
| *modereg = SYSMGR_EMACGRP_CTRL_PHYSEL_ENUM_GMII_MII; |
| return 0; |
| } |
| |
| if (!strcmp(phymode, "rgmii")) { |
| *modereg = SYSMGR_EMACGRP_CTRL_PHYSEL_ENUM_RGMII; |
| return 0; |
| } |
| |
| if (!strcmp(phymode, "rmii")) { |
| *modereg = SYSMGR_EMACGRP_CTRL_PHYSEL_ENUM_RMII; |
| return 0; |
| } |
| |
| return -EINVAL; |
| } |
| |
| int socfpga_eth_reset_common(void (*resetfn)(const u8 of_reset_id, |
| const u8 phymode)) |
| { |
| const void *fdt = gd->fdt_blob; |
| struct fdtdec_phandle_args args; |
| const char *phy_mode; |
| u32 phy_modereg; |
| int nodes[2]; /* Max. two GMACs */ |
| int ret, count; |
| int i, node; |
| |
| count = fdtdec_find_aliases_for_id(fdt, "ethernet", |
| COMPAT_ALTERA_SOCFPGA_DWMAC, |
| nodes, ARRAY_SIZE(nodes)); |
| for (i = 0; i < count; i++) { |
| node = nodes[i]; |
| if (node <= 0) |
| continue; |
| |
| ret = fdtdec_parse_phandle_with_args(fdt, node, "resets", |
| "#reset-cells", 1, 0, |
| &args); |
| if (ret || (args.args_count != 1)) { |
| debug("GMAC%i: Failed to parse DT 'resets'!\n", i); |
| continue; |
| } |
| |
| phy_mode = fdt_getprop(fdt, node, "phy-mode", NULL); |
| ret = dwmac_phymode_to_modereg(phy_mode, &phy_modereg); |
| if (ret) { |
| debug("GMAC%i: Failed to parse DT 'phy-mode'!\n", i); |
| continue; |
| } |
| |
| resetfn(args.args[0], phy_modereg); |
| } |
| |
| return 0; |
| } |
| #endif |
| |
| #ifndef CONFIG_SPL_BUILD |
| static int do_bridge(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[]) |
| { |
| if (argc != 2) |
| return CMD_RET_USAGE; |
| |
| argv++; |
| |
| switch (*argv[0]) { |
| case 'e': /* Enable */ |
| do_bridge_reset(1); |
| break; |
| case 'd': /* Disable */ |
| do_bridge_reset(0); |
| break; |
| default: |
| return CMD_RET_USAGE; |
| } |
| |
| return 0; |
| } |
| |
| U_BOOT_CMD(bridge, 2, 1, do_bridge, |
| "SoCFPGA HPS FPGA bridge control", |
| "enable - Enable HPS-to-FPGA, FPGA-to-HPS, LWHPS-to-FPGA bridges\n" |
| "bridge disable - Enable HPS-to-FPGA, FPGA-to-HPS, LWHPS-to-FPGA bridges\n" |
| "" |
| ); |
| |
| #endif |