| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright (C) 2016 Stefan Roese <sr@denx.de> |
| */ |
| |
| #include <common.h> |
| #include <altera.h> |
| #include <log.h> |
| #include <spi.h> |
| #include <asm/io.h> |
| #include <linux/errno.h> |
| |
| /* Write the RBF data to FPGA via SPI */ |
| static int program_write(int spi_bus, int spi_dev, const void *rbf_data, |
| unsigned long rbf_size) |
| { |
| struct spi_slave *slave; |
| int ret; |
| |
| debug("%s (%d): data=%p size=%ld\n", |
| __func__, __LINE__, rbf_data, rbf_size); |
| |
| /* FIXME: How to get the max. SPI clock and SPI mode? */ |
| slave = spi_setup_slave(spi_bus, spi_dev, 27777777, SPI_MODE_3); |
| if (!slave) |
| return -1; |
| |
| if (spi_claim_bus(slave)) |
| return -1; |
| |
| ret = spi_xfer(slave, rbf_size * 8, rbf_data, (void *)rbf_data, |
| SPI_XFER_BEGIN | SPI_XFER_END); |
| |
| spi_release_bus(slave); |
| |
| return ret; |
| } |
| |
| /* |
| * This is the interface used by FPGA driver. |
| * Return 0 for sucess, non-zero for error. |
| */ |
| int stratixv_load(Altera_desc *desc, const void *rbf_data, size_t rbf_size) |
| { |
| altera_board_specific_func *pfns = desc->iface_fns; |
| int cookie = desc->cookie; |
| int spi_bus; |
| int spi_dev; |
| int ret = 0; |
| |
| if ((u32)rbf_data & 0x3) { |
| puts("FPGA: Unaligned data, realign to 32bit boundary.\n"); |
| return -EINVAL; |
| } |
| |
| /* Run the pre configuration function if there is one */ |
| if (pfns->pre) |
| (pfns->pre)(cookie); |
| |
| /* Establish the initial state */ |
| if (pfns->config) { |
| /* De-assert nCONFIG */ |
| (pfns->config)(false, true, cookie); |
| |
| /* nConfig minimum low pulse width is 2us */ |
| udelay(200); |
| |
| /* Assert nCONFIG */ |
| (pfns->config)(true, true, cookie); |
| |
| /* nCONFIG high to first rising clock on DCLK min 1506 us */ |
| udelay(1600); |
| } |
| |
| /* Write the RBF data to FPGA */ |
| if (pfns->write) { |
| /* |
| * Use board specific data function to write bitstream |
| * into the FPGA |
| */ |
| ret = (pfns->write)(rbf_data, rbf_size, true, cookie); |
| } else { |
| /* |
| * Use common SPI functions to write bitstream into the |
| * FPGA |
| */ |
| spi_bus = COOKIE2SPI_BUS(cookie); |
| spi_dev = COOKIE2SPI_DEV(cookie); |
| ret = program_write(spi_bus, spi_dev, rbf_data, rbf_size); |
| } |
| if (ret) |
| return ret; |
| |
| /* Check done pin */ |
| if (pfns->done) { |
| ret = (pfns->done)(cookie); |
| |
| if (ret) |
| printf("Error: DONE not set (ret=%d)!\n", ret); |
| } |
| |
| return ret; |
| } |