ARM: dts: stm32: Sync DT with v4.20 kernel for stm32f7
Synchronize stm32f7 device tree with kernel v4.20.
All pinctrl bindings are updated.
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
diff --git a/arch/arm/dts/stm32f746-disco.dts b/arch/arm/dts/stm32f746-disco.dts
index d568765..e3a7bd3 100644
--- a/arch/arm/dts/stm32f746-disco.dts
+++ b/arch/arm/dts/stm32f746-disco.dts
@@ -1,10 +1,5 @@
/*
- * Copyright 2016 - Michael Kurz <michi.kurz@gmail.com>
- * Copyright 2016 - Vikas MANOCHA <vikas.manocha@st.com>
- *
- * Based on:
- * stm32f469-disco.dts from Linux
- * Copyright 2016 - Lee Jones <lee.jones@linaro.org>
+ * Copyright 2017 - Vikas MANOCHA <vikas.manocha@st.com>
*
* This file is dual-licensed: you can use it either under the terms
* of the GPL or the X11 license, at your option. Note that this dual
@@ -47,7 +42,8 @@
/dts-v1/;
#include "stm32f746.dtsi"
-#include <dt-bindings/memory/stm32-sdram.h>
+#include "stm32f746-pinctrl.dtsi"
+#include <dt-bindings/input/input.h>
#include <dt-bindings/gpio/gpio.h>
/ {
@@ -55,7 +51,7 @@
compatible = "st,stm32f746-disco", "st,stm32f746";
chosen {
- bootargs = "root=/dev/ram rdinit=/linuxrc";
+ bootargs = "root=/dev/ram";
stdout-path = "serial0:115200n8";
};
@@ -67,39 +63,69 @@
serial0 = &usart1;
};
+ usbotg_hs_phy: usb-phy {
+ #phy-cells = <0>;
+ compatible = "usb-nop-xceiv";
+ clocks = <&rcc 0 STM32F7_AHB1_CLOCK(OTGHSULPI)>;
+ clock-names = "main_clk";
+ };
+
+ /* This turns on vbus for otg fs for host mode (dwc2) */
+ vcc5v_otg_fs: vcc5v-otg-fs-regulator {
+ compatible = "regulator-fixed";
+ gpio = <&gpiod 5 0>;
+ regulator-name = "vcc5_host1";
+ regulator-always-on;
+ };
+
+ mmc_vcard: mmc_vcard {
+ compatible = "regulator-fixed";
+ regulator-name = "mmc_vcard";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ };
};
&clk_hse {
clock-frequency = <25000000>;
};
-&pinctrl {
- usart1_pins_a: usart1@0 {
- pins1 {
- pinmux = <STM32F746_PA9_FUNC_USART1_TX>;
- bias-disable;
- drive-push-pull;
- slew-rate = <2>;
- };
- pins2 {
- pinmux = <STM32F746_PB7_FUNC_USART1_RX>;
- bias-disable;
- };
- };
+&i2c1 {
+ pinctrl-0 = <&i2c1_pins_b>;
+ pinctrl-names = "default";
+ i2c-scl-rising-time-ns = <185>;
+ i2c-scl-falling-time-ns = <20>;
+ status = "okay";
+};
+
+&sdio1 {
+ status = "okay";
+ vmmc-supply = <&mmc_vcard>;
+ cd-gpios = <&gpioc 13 GPIO_ACTIVE_LOW>;
+ pinctrl-names = "default", "opendrain";
+ pinctrl-0 = <&sdio_pins_a>;
+ pinctrl-1 = <&sdio_pins_od_a>;
+ bus-width = <4>;
};
&usart1 {
- pinctrl-0 = <&usart1_pins_a>;
+ pinctrl-0 = <&usart1_pins_b>;
pinctrl-names = "default";
status = "okay";
};
-&sdio {
+&usbotg_fs {
+ dr_mode = "host";
+ pinctrl-0 = <&usbotg_fs_pins_a>;
+ pinctrl-names = "default";
status = "okay";
- cd-gpios = <&gpioc 13 GPIO_ACTIVE_LOW>;
- pinctrl-names = "default", "opendrain";
- pinctrl-0 = <&sdio_pins>;
- pinctrl-1 = <&sdio_pins_od>;
- bus-width = <4>;
- max-frequency = <25000000>;
+};
+
+&usbotg_hs {
+ dr_mode = "host";
+ phys = <&usbotg_hs_phy>;
+ phy-names = "usb2-phy";
+ pinctrl-0 = <&usbotg_hs_pins_b>;
+ pinctrl-names = "default";
+ status = "okay";
};