blob: 0820f6fc7a3fbce01dfeb1348627ff5ac904e973 [file] [log] [blame]
Heiko Schocher578056c2015-06-15 14:56:41 +02001/*
2 * (C) Copyright 2013 Siemens Schweiz AG
3 * (C) Heiko Schocher, DENX Software Engineering, hs@denx.de.
4 *
5 * Based on:
6 * U-Boot file:/include/configs/am335x_evm.h
7 *
8 * Copyright (C) 2011 Texas Instruments Incorporated - http://www.ti.com/
9 *
10 * SPDX-License-Identifier: GPL-2.0+
11 */
12
13#ifndef __CONFIG_RASTABAN_H
14#define __CONFIG_RASTABAN_H
15
16#include "siemens-am33x-common.h"
17
Heiko Schocher578056c2015-06-15 14:56:41 +020018#define DDR_PLL_FREQ 303
19#undef CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC
20
21/* FWD Button = 27
22 * SRV Button = 87 */
23#define BOARD_DFU_BUTTON_GPIO 27
24#define GPIO_LAN9303_NRST 88 /* GPIO2_24 = gpio88 */
25/* In dfu mode keep led1 on */
26#define CONFIG_ENV_SETTINGS_BUTTONS_AND_LEDS \
27 "button_dfu0=27\0" \
28 "button_dfu1=87\0" \
29 "led0=3,0,1\0" \
30 "led1=4,0,0\0" \
31 "led2=5,0,1\0" \
32 "led3=62,0,1\0" \
33 "led4=60,0,1\0" \
34 "led5=63,0,1\0"
35
Heiko Schocher578056c2015-06-15 14:56:41 +020036 /* Physical Memory Map */
37#define CONFIG_MAX_RAM_BANK_SIZE (1024 << 20) /* 1GB */
38
39/* I2C Configuration */
40#define CONFIG_SYS_I2C_SPEED 100000
41
42#define CONFIG_SYS_I2C_EEPROM_ADDR 0x50
43#define EEPROM_ADDR_DDR3 0x90
44#define EEPROM_ADDR_CHIP 0x120
45
Heiko Schocher578056c2015-06-15 14:56:41 +020046#undef CONFIG_MII
47#undef CONFIG_PHY_GIGE
48#define CONFIG_PHY_SMSC
49
50#define CONFIG_FACTORYSET
51
Heiko Schocher578056c2015-06-15 14:56:41 +020052/* Define own nand partitions */
53#define CONFIG_ENV_OFFSET_REDUND 0x2E0000
54#define CONFIG_ENV_SIZE_REDUND 0x2000
55#define CONFIG_ENV_RANGE (4 * CONFIG_SYS_ENV_SECT_SIZE)
56
Heiko Schocher578056c2015-06-15 14:56:41 +020057#define MTDPARTS_DEFAULT MTDPARTS_DEFAULT_V3
58
59#ifndef CONFIG_SPL_BUILD
60
61/* Default env settings */
62#define CONFIG_EXTRA_ENV_SETTINGS \
63 "hostname=rastaban\0" \
Heiko Schocher6b3943f2016-06-07 08:55:45 +020064 "ubi_off=2048\0"\
Heiko Schocher578056c2015-06-15 14:56:41 +020065 "nand_img_size=0x400000\0" \
66 "optargs=\0" \
67 "preboot=draco_led 0\0" \
68 CONFIG_ENV_SETTINGS_BUTTONS_AND_LEDS \
69 CONFIG_ENV_SETTINGS_V2 \
70 CONFIG_ENV_SETTINGS_NAND_V2
71
72#ifndef CONFIG_RESTORE_FLASH
73/* set to negative value for no autoboot */
Heiko Schocher578056c2015-06-15 14:56:41 +020074
75#define CONFIG_BOOTCOMMAND \
76"if dfubutton; then " \
77 "run dfu_start; " \
78 "reset; " \
79"fi;" \
80"run nand_boot;" \
81"run nand_boot_backup;" \
82"reset;"
83
Heiko Schocher578056c2015-06-15 14:56:41 +020084#else
Heiko Schocher578056c2015-06-15 14:56:41 +020085
86#define CONFIG_BOOTCOMMAND \
87 "setenv autoload no; " \
88 "dhcp; " \
89 "if tftp 80000000 debrick.scr; then " \
90 "source 80000000; " \
91 "fi"
92#endif
93#endif /* CONFIG_SPL_BUILD */
94#endif /* ! __CONFIG_RASTABAN_H */