Akshay Saraswat | acbb1eb | 2013-03-20 21:00:56 +0000 | [diff] [blame] | 1 | /* |
| 2 | * Advanced Crypto Engine - SHA Firmware |
| 3 | * Copyright (c) 2012 Samsung Electronics |
| 4 | * |
Wolfgang Denk | 1a45966 | 2013-07-08 09:37:19 +0200 | [diff] [blame] | 5 | * SPDX-License-Identifier: GPL-2.0+ |
Akshay Saraswat | acbb1eb | 2013-03-20 21:00:56 +0000 | [diff] [blame] | 6 | */ |
| 7 | #include <common.h> |
Przemyslaw Marczak | 0bd9372 | 2014-03-25 10:58:21 +0100 | [diff] [blame] | 8 | #include "ace_sha.h" |
| 9 | |
| 10 | #ifdef CONFIG_SHA_HW_ACCEL |
Jeroen Hofstee | 2b9912e | 2014-06-12 22:27:12 +0200 | [diff] [blame] | 11 | #include <u-boot/sha256.h> |
| 12 | #include <u-boot/sha1.h> |
Masahiro Yamada | 1221ce4 | 2016-09-21 11:28:55 +0900 | [diff] [blame] | 13 | #include <linux/errno.h> |
Akshay Saraswat | acbb1eb | 2013-03-20 21:00:56 +0000 | [diff] [blame] | 14 | |
| 15 | /* SHA1 value for the message of zero length */ |
| 16 | static const unsigned char sha1_digest_emptymsg[SHA1_SUM_LEN] = { |
| 17 | 0xDA, 0x39, 0xA3, 0xEE, 0x5E, 0x6B, 0x4B, 0x0D, |
| 18 | 0x32, 0x55, 0xBF, 0xFF, 0x95, 0x60, 0x18, 0x90, |
| 19 | 0xAF, 0xD8, 0x07, 0x09}; |
| 20 | |
| 21 | /* SHA256 value for the message of zero length */ |
| 22 | static const unsigned char sha256_digest_emptymsg[SHA256_SUM_LEN] = { |
| 23 | 0xE3, 0xB0, 0xC4, 0x42, 0x98, 0xFC, 0x1C, 0x14, |
| 24 | 0x9A, 0xFB, 0xF4, 0xC8, 0x99, 0x6F, 0xB9, 0x24, |
| 25 | 0x27, 0xAE, 0x41, 0xE4, 0x64, 0x9B, 0x93, 0x4C, |
| 26 | 0xA4, 0x95, 0x99, 0x1B, 0x78, 0x52, 0xB8, 0x55}; |
| 27 | |
| 28 | int ace_sha_hash_digest(const unsigned char *pbuf, unsigned int buf_len, |
| 29 | unsigned char *pout, unsigned int hash_type) |
| 30 | { |
| 31 | unsigned int i, reg, len; |
| 32 | unsigned int *pdigest; |
| 33 | struct exynos_ace_sfr *ace_sha_reg = |
| 34 | (struct exynos_ace_sfr *)samsung_get_base_ace_sfr(); |
| 35 | |
| 36 | if (buf_len == 0) { |
| 37 | /* ACE H/W cannot compute hash value for empty string */ |
| 38 | if (hash_type == ACE_SHA_TYPE_SHA1) |
| 39 | memcpy(pout, sha1_digest_emptymsg, SHA1_SUM_LEN); |
| 40 | else |
| 41 | memcpy(pout, sha256_digest_emptymsg, SHA256_SUM_LEN); |
| 42 | return 0; |
| 43 | } |
| 44 | |
| 45 | /* Flush HRDMA */ |
| 46 | writel(ACE_FC_HRDMACFLUSH_ON, &ace_sha_reg->fc_hrdmac); |
| 47 | writel(ACE_FC_HRDMACFLUSH_OFF, &ace_sha_reg->fc_hrdmac); |
| 48 | |
| 49 | /* Set byte swap of data in */ |
| 50 | writel(ACE_HASH_SWAPDI_ON | ACE_HASH_SWAPDO_ON | ACE_HASH_SWAPIV_ON, |
| 51 | &ace_sha_reg->hash_byteswap); |
| 52 | |
| 53 | /* Select Hash input mux as external source */ |
| 54 | reg = readl(&ace_sha_reg->fc_fifoctrl); |
| 55 | reg = (reg & ~ACE_FC_SELHASH_MASK) | ACE_FC_SELHASH_EXOUT; |
| 56 | writel(reg, &ace_sha_reg->fc_fifoctrl); |
| 57 | |
| 58 | /* Set Hash as SHA1 or SHA256 and start Hash engine */ |
| 59 | reg = (hash_type == ACE_SHA_TYPE_SHA1) ? |
| 60 | ACE_HASH_ENGSEL_SHA1HASH : ACE_HASH_ENGSEL_SHA256HASH; |
| 61 | reg |= ACE_HASH_STARTBIT_ON; |
| 62 | writel(reg, &ace_sha_reg->hash_control); |
| 63 | |
| 64 | /* Enable FIFO mode */ |
| 65 | writel(ACE_HASH_FIFO_ON, &ace_sha_reg->hash_fifo_mode); |
| 66 | |
| 67 | /* Set message length */ |
| 68 | writel(buf_len, &ace_sha_reg->hash_msgsize_low); |
| 69 | writel(0, &ace_sha_reg->hash_msgsize_high); |
| 70 | |
| 71 | /* Set HRDMA */ |
| 72 | writel((unsigned int)pbuf, &ace_sha_reg->fc_hrdmas); |
| 73 | writel(buf_len, &ace_sha_reg->fc_hrdmal); |
| 74 | |
| 75 | while ((readl(&ace_sha_reg->hash_status) & ACE_HASH_MSGDONE_MASK) == |
| 76 | ACE_HASH_MSGDONE_OFF) { |
| 77 | /* |
| 78 | * PRNG error bit goes HIGH if a PRNG request occurs without |
| 79 | * a complete seed setup. We are using this bit to check h/w |
| 80 | * fault because proper setup is not expected in that case. |
| 81 | */ |
| 82 | if ((readl(&ace_sha_reg->hash_status) |
| 83 | & ACE_HASH_PRNGERROR_MASK) == ACE_HASH_PRNGERROR_ON) |
| 84 | return -EBUSY; |
| 85 | } |
| 86 | |
| 87 | /* Clear MSG_DONE bit */ |
| 88 | writel(ACE_HASH_MSGDONE_ON, &ace_sha_reg->hash_status); |
| 89 | |
| 90 | /* Read hash result */ |
| 91 | pdigest = (unsigned int *)pout; |
| 92 | len = (hash_type == ACE_SHA_TYPE_SHA1) ? SHA1_SUM_LEN : SHA256_SUM_LEN; |
| 93 | |
| 94 | for (i = 0; i < len / 4; i++) |
| 95 | pdigest[i] = readl(&ace_sha_reg->hash_result[i]); |
| 96 | |
| 97 | /* Clear HRDMA pending bit */ |
| 98 | writel(ACE_FC_HRDMA, &ace_sha_reg->fc_intpend); |
| 99 | |
| 100 | return 0; |
| 101 | } |
| 102 | |
| 103 | void hw_sha256(const unsigned char *pbuf, unsigned int buf_len, |
| 104 | unsigned char *pout, unsigned int chunk_size) |
| 105 | { |
| 106 | if (ace_sha_hash_digest(pbuf, buf_len, pout, ACE_SHA_TYPE_SHA256)) |
| 107 | debug("ACE was not setup properly or it is faulty\n"); |
| 108 | } |
| 109 | |
| 110 | void hw_sha1(const unsigned char *pbuf, unsigned int buf_len, |
| 111 | unsigned char *pout, unsigned int chunk_size) |
| 112 | { |
| 113 | if (ace_sha_hash_digest(pbuf, buf_len, pout, ACE_SHA_TYPE_SHA1)) |
| 114 | debug("ACE was not setup properly or it is faulty\n"); |
| 115 | } |
Przemyslaw Marczak | 0bd9372 | 2014-03-25 10:58:21 +0100 | [diff] [blame] | 116 | #endif /* CONFIG_SHA_HW_ACCEL */ |
| 117 | |
| 118 | #ifdef CONFIG_LIB_HW_RAND |
| 119 | static unsigned int seed_done; |
| 120 | |
| 121 | void srand(unsigned int seed) |
| 122 | { |
| 123 | struct exynos_ace_sfr *reg = |
| 124 | (struct exynos_ace_sfr *)samsung_get_base_ace_sfr(); |
| 125 | int i, status; |
| 126 | |
| 127 | /* Seed data */ |
| 128 | for (i = 0; i < ACE_HASH_PRNG_REG_NUM; i++) |
| 129 | writel(seed << i, ®->hash_seed[i]); |
| 130 | |
| 131 | /* Wait for seed setup done */ |
| 132 | while (1) { |
| 133 | status = readl(®->hash_status); |
| 134 | if ((status & ACE_HASH_SEEDSETTING_MASK) || |
| 135 | (status & ACE_HASH_PRNGERROR_MASK)) |
| 136 | break; |
| 137 | } |
| 138 | |
| 139 | seed_done = 1; |
| 140 | } |
| 141 | |
| 142 | unsigned int rand(void) |
| 143 | { |
| 144 | struct exynos_ace_sfr *reg = |
| 145 | (struct exynos_ace_sfr *)samsung_get_base_ace_sfr(); |
| 146 | int i, status; |
| 147 | unsigned int seed = (unsigned int)&status; |
| 148 | unsigned int ret = 0; |
| 149 | |
| 150 | if (!seed_done) |
| 151 | srand(seed); |
| 152 | |
| 153 | /* Start PRNG */ |
| 154 | writel(ACE_HASH_ENGSEL_PRNG | ACE_HASH_STARTBIT_ON, ®->hash_control); |
| 155 | |
| 156 | /* Wait for PRNG done */ |
| 157 | while (1) { |
| 158 | status = readl(®->hash_status); |
| 159 | if (status & ACE_HASH_PRNGDONE_MASK) |
| 160 | break; |
| 161 | if (status & ACE_HASH_PRNGERROR_MASK) { |
| 162 | seed_done = 0; |
| 163 | return 0; |
| 164 | } |
| 165 | } |
| 166 | |
| 167 | /* Clear Done IRQ */ |
| 168 | writel(ACE_HASH_PRNGDONE_MASK, ®->hash_status); |
| 169 | |
| 170 | /* Read a PRNG result */ |
| 171 | for (i = 0; i < ACE_HASH_PRNG_REG_NUM; i++) |
| 172 | ret += readl(®->hash_prng[i]); |
| 173 | |
| 174 | seed_done = 0; |
| 175 | return ret; |
| 176 | } |
| 177 | |
| 178 | unsigned int rand_r(unsigned int *seedp) |
| 179 | { |
| 180 | srand(*seedp); |
| 181 | |
| 182 | return rand(); |
| 183 | } |
| 184 | #endif /* CONFIG_LIB_HW_RAND */ |