| Codrin Ciubotariu | 6706b11 | 2015-01-12 14:08:33 +0200 | [diff] [blame^] | 1 | This file contains information for VSC9953, a Vitesse L2 Switch IP |
| 2 | which is integrated in the T1040/T1020 Freescale SoCs. |
| 3 | |
| 4 | About Device: |
| 5 | ============= |
| 6 | VSC9953 is an 8-port Gigabit Ethernet switch supports the following features: |
| 7 | - 8192 MAC addresses |
| 8 | - Static Address provisioning |
| 9 | - Dynamic learning of MAC addresses and aging |
| 10 | - 4096 VLANs |
| 11 | - Independent and shared VLAN learning (IVL, SVL) |
| 12 | - Policing with storm control and MC/BC protection |
| 13 | - IPv4 and IPv6 multicast |
| 14 | - Jumbo frames (9.6 KB) |
| 15 | - Access Control List |
| 16 | - VLAN editing, translation and remarking |
| 17 | - RMON counters per port |
| 18 | |
| 19 | Switch interfaces: |
| 20 | - 8 Gigabit switch ports (ports 0 to 7) are external and are connected to external PHYs |
| 21 | - 2 switch ports (ports 8 and 9) of 2.5 G are connected (fixed links) |
| 22 | to FMan ports (FM1@DTSEC1 and FM1@DTSEC2) |
| 23 | |
| 24 | Commands Overview: |
| 25 | ============= |
| 26 | Commands supported |
| 27 | - enable/disable a port |
| 28 | - check a port's link speed, duplexity and status. |
| 29 | |
| 30 | Commands syntax |
| 31 | ethsw port <port_nr> enable|disable - enable/disable an l2 switch port |
| 32 | ethsw port <port_nr> show - show an l2 switch port's configuration |
| 33 | |
| 34 | port_nr=0..9; use "all" for all ports |
| 35 | |
| 36 | => ethsw port all show |
| 37 | Port Status Link Speed Duplex |
| 38 | 0 enabled down 10 half |
| 39 | 1 enabled down 10 half |
| 40 | 2 enabled down 10 half |
| 41 | 3 enabled up 1000 full |
| 42 | 4 disabled down - half |
| 43 | 5 disabled down - half |
| 44 | 6 disabled down - half |
| 45 | 7 disabled down - half |
| 46 | 8 enabled up 2500 full |
| 47 | 9 enabled up 2500 full |
| 48 | => |