Yuiko Oshino | d2c3197 | 2017-08-11 12:44:58 -0400 | [diff] [blame] | 1 | /* |
| 2 | * Copyright (c) 2017 Microchip Technology Inc. All rights reserved. |
| 3 | * |
| 4 | * SPDX-License-Identifier: GPL-2.0+ |
| 5 | */ |
| 6 | |
| 7 | #include <console.h> |
| 8 | #include <watchdog.h> |
| 9 | |
| 10 | /* USB Vendor Requests */ |
| 11 | #define USB_VENDOR_REQUEST_WRITE_REGISTER 0xA0 |
| 12 | #define USB_VENDOR_REQUEST_READ_REGISTER 0xA1 |
| 13 | #define USB_VENDOR_REQUEST_GET_STATS 0xA2 |
| 14 | |
| 15 | /* Tx Command A */ |
| 16 | #define TX_CMD_A_FCS BIT(22) |
| 17 | #define TX_CMD_A_LEN_MASK 0x000FFFFF |
| 18 | |
| 19 | /* Rx Command A */ |
| 20 | #define RX_CMD_A_RXE BIT(18) |
| 21 | #define RX_CMD_A_LEN_MASK 0x00003FFF |
| 22 | |
| 23 | /* SCSRs */ |
| 24 | #define ID_REV 0x00 |
| 25 | #define ID_REV_CHIP_ID_MASK 0xFFFF0000 |
| 26 | #define ID_REV_CHIP_ID_7500 0x7500 |
| 27 | #define ID_REV_CHIP_ID_7800 0x7800 |
| 28 | #define ID_REV_CHIP_ID_7850 0x7850 |
| 29 | |
| 30 | #define INT_STS 0x0C |
| 31 | |
| 32 | #define HW_CFG 0x010 |
| 33 | #define HW_CFG_LRST BIT(1) |
| 34 | |
| 35 | #define PMT_CTL 0x014 |
| 36 | #define PMT_CTL_PHY_PWRUP BIT(10) |
| 37 | #define PMT_CTL_READY BIT(7) |
| 38 | #define PMT_CTL_PHY_RST BIT(4) |
| 39 | |
| 40 | #define E2P_CMD 0x040 |
| 41 | #define E2P_CMD_EPC_BUSY BIT(31) |
| 42 | #define E2P_CMD_EPC_CMD_READ 0x00000000 |
| 43 | #define E2P_CMD_EPC_TIMEOUT BIT(10) |
| 44 | #define E2P_CMD_EPC_ADDR_MASK 0x000001FF |
| 45 | |
| 46 | #define E2P_DATA 0x044 |
| 47 | |
| 48 | #define RFE_CTL_BCAST_EN BIT(10) |
| 49 | #define RFE_CTL_DA_PERFECT BIT(1) |
| 50 | |
| 51 | #define FCT_RX_CTL_EN BIT(31) |
| 52 | |
| 53 | #define FCT_TX_CTL_EN BIT(31) |
| 54 | |
| 55 | #define MAC_CR 0x100 |
| 56 | #define MAC_CR_ADP BIT(13) |
| 57 | #define MAC_CR_AUTO_DUPLEX BIT(12) |
| 58 | #define MAC_CR_AUTO_SPEED BIT(11) |
| 59 | |
| 60 | #define MAC_RX 0x104 |
| 61 | #define MAC_RX_FCS_STRIP BIT(4) |
| 62 | #define MAC_RX_RXEN BIT(0) |
| 63 | |
| 64 | #define MAC_TX 0x108 |
| 65 | #define MAC_TX_TXEN BIT(0) |
| 66 | |
| 67 | #define FLOW 0x10C |
| 68 | #define FLOW_CR_TX_FCEN BIT(30) |
| 69 | #define FLOW_CR_RX_FCEN BIT(29) |
| 70 | |
| 71 | #define RX_ADDRH 0x118 |
| 72 | #define RX_ADDRL 0x11C |
| 73 | |
| 74 | #define MII_ACC 0x120 |
| 75 | #define MII_ACC_MII_READ 0x00000000 |
| 76 | #define MII_ACC_MII_WRITE 0x00000002 |
| 77 | #define MII_ACC_MII_BUSY BIT(0) |
| 78 | |
| 79 | #define MII_DATA 0x124 |
| 80 | |
| 81 | #define SS_USB_PKT_SIZE 1024 |
| 82 | #define HS_USB_PKT_SIZE 512 |
| 83 | #define FS_USB_PKT_SIZE 64 |
| 84 | |
| 85 | #define MAX_RX_FIFO_SIZE (12 * 1024) |
| 86 | #define MAX_TX_FIFO_SIZE (12 * 1024) |
| 87 | #define DEFAULT_BULK_IN_DELAY 0x0800 |
| 88 | |
| 89 | #define EEPROM_INDICATOR 0xA5 |
| 90 | #define EEPROM_MAC_OFFSET 0x01 |
| 91 | |
| 92 | /* Some extra defines */ |
| 93 | #define LAN7X_INTERNAL_PHY_ID 1 |
| 94 | |
| 95 | #define LAN7X_MAC_RX_MAX_SIZE(mtu) \ |
| 96 | ((mtu) << 16) /* Max frame size */ |
| 97 | #define LAN7X_MAC_RX_MAX_SIZE_DEFAULT \ |
| 98 | LAN7X_MAC_RX_MAX_SIZE(ETH_FRAME_LEN + 4 /* VLAN */ + 4 /* CRC */) |
| 99 | |
| 100 | /* Timeouts */ |
| 101 | #define USB_CTRL_SET_TIMEOUT_MS 5000 |
| 102 | #define USB_CTRL_GET_TIMEOUT_MS 5000 |
| 103 | #define USB_BULK_SEND_TIMEOUT_MS 5000 |
| 104 | #define USB_BULK_RECV_TIMEOUT_MS 5000 |
| 105 | #define TIMEOUT_RESOLUTION_MS 50 |
| 106 | #define PHY_CONNECT_TIMEOUT_MS 5000 |
| 107 | |
| 108 | #define RX_URB_SIZE 2048 |
| 109 | |
| 110 | /* driver private */ |
| 111 | struct lan7x_private { |
| 112 | struct ueth_data ueth; |
| 113 | u32 chipid; /* Chip or device ID */ |
| 114 | struct mii_dev *mdiobus; |
| 115 | struct phy_device *phydev; |
| 116 | }; |
| 117 | |
| 118 | /* |
| 119 | * Lan7x infrastructure commands |
| 120 | */ |
| 121 | |
| 122 | int lan7x_write_reg(struct usb_device *udev, u32 index, u32 data); |
| 123 | |
| 124 | int lan7x_read_reg(struct usb_device *udev, u32 index, u32 *data); |
| 125 | |
| 126 | static inline int lan7x_wait_for_bit(struct usb_device *udev, |
| 127 | const char *prefix, const u32 reg, |
| 128 | const u32 mask, const bool set, |
| 129 | const unsigned int timeout_ms, |
| 130 | const bool breakable) |
| 131 | { |
| 132 | u32 val; |
| 133 | unsigned long start = get_timer(0); |
| 134 | |
| 135 | while (1) { |
| 136 | lan7x_read_reg(udev, reg, &val); |
| 137 | |
| 138 | if (!set) |
| 139 | val = ~val; |
| 140 | |
| 141 | if ((val & mask) == mask) |
| 142 | return 0; |
| 143 | |
| 144 | if (get_timer(start) > timeout_ms) |
| 145 | break; |
| 146 | |
| 147 | if (breakable && ctrlc()) { |
| 148 | puts("Abort\n"); |
| 149 | return -EINTR; |
| 150 | } |
| 151 | |
| 152 | udelay(1); |
| 153 | WATCHDOG_RESET(); |
| 154 | } |
| 155 | |
| 156 | debug("%s: Timeout (reg=0x%x mask=%08x wait_set=%i)\n", prefix, reg, |
| 157 | mask, set); |
| 158 | |
| 159 | return -ETIMEDOUT; |
| 160 | } |
| 161 | |
| 162 | int lan7x_mdio_read(struct usb_device *udev, int phy_id, int idx); |
| 163 | |
| 164 | void lan7x_mdio_write(struct usb_device *udev, int phy_id, int idx, |
| 165 | int regval); |
| 166 | |
| 167 | static inline int lan7x_mdio_wait_for_bit(struct usb_device *udev, |
| 168 | const char *prefix, |
| 169 | int phy_id, const u32 reg, |
| 170 | const u32 mask, const bool set, |
| 171 | const unsigned int timeout_ms, |
| 172 | const bool breakable) |
| 173 | { |
| 174 | u32 val; |
| 175 | unsigned long start = get_timer(0); |
| 176 | |
| 177 | while (1) { |
| 178 | val = lan7x_mdio_read(udev, phy_id, reg); |
| 179 | |
| 180 | if (!set) |
| 181 | val = ~val; |
| 182 | |
| 183 | if ((val & mask) == mask) |
| 184 | return 0; |
| 185 | |
| 186 | if (get_timer(start) > timeout_ms) |
| 187 | break; |
| 188 | |
| 189 | if (breakable && ctrlc()) { |
| 190 | puts("Abort\n"); |
| 191 | return -EINTR; |
| 192 | } |
| 193 | |
| 194 | udelay(1); |
| 195 | WATCHDOG_RESET(); |
| 196 | } |
| 197 | |
| 198 | debug("%s: Timeout (reg=0x%x mask=%08x wait_set=%i)\n", prefix, reg, |
| 199 | mask, set); |
| 200 | |
| 201 | return -ETIMEDOUT; |
| 202 | } |
| 203 | |
| 204 | int lan7x_phylib_register(struct udevice *udev); |
| 205 | |
| 206 | int lan7x_eth_phylib_connect(struct udevice *udev, struct ueth_data *dev); |
| 207 | |
| 208 | int lan7x_eth_phylib_config_start(struct udevice *udev); |
| 209 | |
| 210 | int lan7x_pmt_phy_reset(struct usb_device *udev, |
| 211 | struct ueth_data *dev); |
| 212 | |
| 213 | int lan7x_update_flowcontrol(struct usb_device *udev, |
| 214 | struct ueth_data *dev, |
| 215 | uint32_t *flow, uint32_t *fct_flow); |
| 216 | |
| 217 | int lan7x_read_eeprom_mac(unsigned char *enetaddr, struct usb_device *udev); |
| 218 | |
| 219 | int lan7x_basic_reset(struct usb_device *udev, |
| 220 | struct ueth_data *dev); |
| 221 | |
| 222 | void lan7x_eth_stop(struct udevice *dev); |
| 223 | |
| 224 | int lan7x_eth_send(struct udevice *dev, void *packet, int length); |
| 225 | |
| 226 | int lan7x_eth_recv(struct udevice *dev, int flags, uchar **packetp); |
| 227 | |
| 228 | int lan7x_free_pkt(struct udevice *dev, uchar *packet, int packet_len); |
| 229 | |
| 230 | int lan7x_eth_remove(struct udevice *dev); |