| Tom Rini | 53633a8 | 2024-02-29 12:33:36 -0500 | [diff] [blame] | 1 | // SPDX-License-Identifier: BSD-3-Clause |
| 2 | /* |
| 3 | * Copyright (c) 2021, Linaro Limited |
| 4 | */ |
| 5 | |
| 6 | #include <dt-bindings/input/input.h> |
| 7 | #include <dt-bindings/interrupt-controller/irq.h> |
| 8 | #include <dt-bindings/spmi/spmi.h> |
| 9 | |
| 10 | / { |
| 11 | thermal-zones { |
| 12 | pmm8155au-2-thermal { |
| 13 | polling-delay-passive = <100>; |
| 14 | polling-delay = <0>; |
| 15 | |
| 16 | thermal-sensors = <&pmm8155au_2_temp>; |
| 17 | |
| 18 | trips { |
| 19 | trip0 { |
| 20 | temperature = <95000>; |
| 21 | hysteresis = <0>; |
| 22 | type = "passive"; |
| 23 | }; |
| 24 | |
| 25 | trip1 { |
| 26 | temperature = <115000>; |
| 27 | hysteresis = <0>; |
| 28 | type = "hot"; |
| 29 | }; |
| 30 | |
| 31 | trip2 { |
| 32 | temperature = <145000>; |
| 33 | hysteresis = <0>; |
| 34 | type = "critical"; |
| 35 | }; |
| 36 | }; |
| 37 | }; |
| 38 | }; |
| 39 | }; |
| 40 | |
| 41 | &spmi_bus { |
| 42 | pmic@4 { |
| 43 | compatible = "qcom,pmm8155au", "qcom,spmi-pmic"; |
| 44 | reg = <0x4 SPMI_USID>; |
| 45 | #address-cells = <1>; |
| 46 | #size-cells = <0>; |
| 47 | |
| 48 | pon@800 { |
| 49 | compatible = "qcom,pm8916-pon"; |
| 50 | reg = <0x0800>; |
| 51 | |
| 52 | status = "disabled"; |
| 53 | }; |
| 54 | |
| 55 | pmm8155au_2_temp: temp-alarm@2400 { |
| 56 | compatible = "qcom,spmi-temp-alarm"; |
| 57 | reg = <0x2400>; |
| 58 | interrupts = <0x4 0x24 0x0 IRQ_TYPE_EDGE_BOTH>; |
| 59 | io-channels = <&pmm8155au_2_adc ADC5_DIE_TEMP>; |
| 60 | io-channel-names = "thermal"; |
| 61 | #thermal-sensor-cells = <0>; |
| 62 | }; |
| 63 | |
| 64 | pmm8155au_2_adc: adc@3100 { |
| 65 | compatible = "qcom,spmi-adc5"; |
| 66 | reg = <0x3100>; |
| 67 | #address-cells = <1>; |
| 68 | #size-cells = <0>; |
| 69 | #io-channel-cells = <1>; |
| 70 | interrupts = <0x4 0x31 0x0 IRQ_TYPE_EDGE_RISING>; |
| 71 | |
| 72 | channel@0 { |
| 73 | reg = <ADC5_REF_GND>; |
| 74 | qcom,pre-scaling = <1 1>; |
| 75 | label = "ref_gnd"; |
| 76 | }; |
| 77 | |
| 78 | channel@1 { |
| 79 | reg = <ADC5_1P25VREF>; |
| 80 | qcom,pre-scaling = <1 1>; |
| 81 | label = "vref_1p25"; |
| 82 | }; |
| 83 | |
| 84 | channel@6 { |
| 85 | reg = <ADC5_DIE_TEMP>; |
| 86 | qcom,pre-scaling = <1 1>; |
| 87 | label = "die_temp"; |
| 88 | }; |
| 89 | }; |
| 90 | |
| 91 | pmm8155au_2_gpios: gpio@c000 { |
| 92 | compatible = "qcom,pmm8155au-gpio", "qcom,spmi-gpio"; |
| 93 | reg = <0xc000>; |
| 94 | gpio-controller; |
| 95 | #gpio-cells = <2>; |
| 96 | gpio-ranges = <&pmm8155au_2_gpios 0 0 10>; |
| 97 | interrupt-controller; |
| 98 | #interrupt-cells = <2>; |
| 99 | }; |
| 100 | }; |
| 101 | |
| 102 | pmic@5 { |
| 103 | compatible = "qcom,pmm8155au", "qcom,spmi-pmic"; |
| 104 | reg = <0x5 SPMI_USID>; |
| 105 | #address-cells = <1>; |
| 106 | #size-cells = <0>; |
| 107 | }; |
| 108 | }; |