blob: 1a0c7f8e5f924c5c876af4dcd6a187b20111cca4 [file] [log] [blame]
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +05301/*
2 * Copyright 2016 Freescale Semiconductor
3 *
4 * SPDX-License-Identifier: GPL-2.0+
5 */
6
7#ifndef __LS1012A_COMMON_H
8#define __LS1012A_COMMON_H
9
10#define CONFIG_FSL_LAYERSCAPE
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053011#define CONFIG_GICV2
12
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053013#include <asm/arch/config.h>
Bharat Bhushan9f076db2017-03-22 12:06:29 +053014#include <asm/arch/stream_id_lsch2.h>
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053015
16#define CONFIG_SUPPORT_RAW_INITRD
17
18#define CONFIG_DISPLAY_BOARDINFO_LATE
19
20#define CONFIG_SYS_TEXT_BASE 0x40100000
21
Hou Zhiqiang904110c2017-01-10 16:44:15 +080022#define CONFIG_SYS_CLK_FREQ 125000000
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053023
24#define CONFIG_SKIP_LOWLEVEL_INIT
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053025
26#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0)
27#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000)
28
29#define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000
30#define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0
31#define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE
Prabhakar Kushwaha7d559602017-01-30 17:05:22 +053032#define CONFIG_SYS_DDR_BLOCK2_BASE 0x880000000ULL
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053033
34/* Generic Timer Definitions */
35#define COUNTER_FREQUENCY CONFIG_SYS_CLK_FREQ/4 /* 25MHz */
36
37/* CSU */
38#define CONFIG_LAYERSCAPE_NS_ACCESS
39
40/* Size of malloc() pool */
41#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024)
42
43/*SPI device */
44#ifdef CONFIG_QSPI_BOOT
45#define CONFIG_SYS_QE_FW_IN_SPIFLASH
46#define CONFIG_SYS_FMAN_FW_ADDR 0x400d0000
47#define CONFIG_ENV_SPI_BUS 0
48#define CONFIG_ENV_SPI_CS 0
49#define CONFIG_ENV_SPI_MAX_HZ 1000000
50#define CONFIG_ENV_SPI_MODE 0x03
51#define CONFIG_SPI_FLASH_SPANSION
52#define CONFIG_FSL_SPI_INTERFACE
53#define CONFIG_SF_DATAFLASH
54
55#define CONFIG_FSL_QSPI
56#define QSPI0_AMBA_BASE 0x40000000
57#define CONFIG_SPI_FLASH_SPANSION
58#define CONFIG_SPI_FLASH_BAR
59
60#define FSL_QSPI_FLASH_SIZE (1 << 24)
61#define FSL_QSPI_FLASH_NUM 2
62
63/*
64 * Environment
65 */
66#define CONFIG_ENV_OVERWRITE
67
68#define CONFIG_ENV_IS_IN_SPI_FLASH
69#define CONFIG_ENV_SIZE 0x40000 /* 256KB */
70#define CONFIG_ENV_OFFSET 0x200000 /* 2MB */
71#define CONFIG_ENV_SECT_SIZE 0x40000
72#endif
73
74/* I2C */
75#define CONFIG_SYS_I2C
76#define CONFIG_SYS_I2C_MXC
77#define CONFIG_SYS_I2C_MXC_I2C1 /* enable I2C bus 1 */
78#define CONFIG_SYS_I2C_MXC_I2C2 /* enable I2C bus 2 */
79
80#define CONFIG_CONS_INDEX 1
81#define CONFIG_SYS_NS16550_SERIAL
82#define CONFIG_SYS_NS16550_REG_SIZE 1
Hou Zhiqiang904110c2017-01-10 16:44:15 +080083#define CONFIG_SYS_NS16550_CLK (get_serial_clock())
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053084
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053085#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
86
87/* Command line configuration */
88#define CONFIG_CMD_ENV
89#undef CONFIG_CMD_IMLS
90
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053091#define CONFIG_SYS_HZ 1000
92
93#define CONFIG_HWCONFIG
94#define HWCONFIG_BUFFER_SIZE 128
95
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053096/* Initial environment variables */
97#define CONFIG_EXTRA_ENV_SETTINGS \
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053098 "verify=no\0" \
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +053099 "loadaddr=0x80100000\0" \
100 "kernel_addr=0x100000\0" \
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +0530101 "fdt_high=0xffffffffffffffff\0" \
102 "initrd_high=0xffffffffffffffff\0" \
103 "kernel_start=0xa00000\0" \
104 "kernel_load=0xa0000000\0" \
105 "kernel_size=0x2800000\0" \
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +0530106
107#define CONFIG_BOOTARGS "console=ttyS0,115200 root=/dev/ram0 " \
Pratiyush Srivastava185e5862016-10-10 18:45:15 +0530108 "earlycon=uart8250,mmio,0x21c0500 quiet lpj=250000"
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +0530109#define CONFIG_BOOTCOMMAND "sf probe 0:0; sf read $kernel_load "\
110 "$kernel_start $kernel_size && "\
111 "bootm $kernel_load"
Prabhakar Kushwaha9d044fc2016-06-03 18:41:34 +0530112
113/* Monitor Command Prompt */
114#define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */
115#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \
116 sizeof(CONFIG_SYS_PROMPT) + 16)
117#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot args buffer */
118#define CONFIG_SYS_LONGHELP
119#define CONFIG_CMDLINE_EDITING 1
120#define CONFIG_AUTO_COMPLETE
121#define CONFIG_SYS_MAXARGS 64 /* max command args */
122
123#define CONFIG_PANIC_HANG
124#define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */
125
126#include <asm/fsl_secure_boot.h>
127
128#endif /* __LS1012A_COMMON_H */