blob: 39423051088daaa1154c501dae35ca707724a346 [file] [log] [blame]
Tom Rini83d290c2018-05-06 17:58:06 -04001// SPDX-License-Identifier: GPL-2.0+
Marcin Niestroja73c8b32017-01-25 09:53:07 +01002/*
3 * Copyright (C) 2011, Texas Instruments, Incorporated - http://www.ti.com/
4 * Copyright (C) 2017, Grinn - http://grinn-global.com/
Marcin Niestroja73c8b32017-01-25 09:53:07 +01005 */
6
7#include <common.h>
8#include <asm/arch/clock.h>
9#include <asm/arch/clk_synthesizer.h>
10#include <asm/arch/cpu.h>
11#include <asm/arch/ddr_defs.h>
12#include <asm/arch/hardware.h>
13#include <asm/arch/omap.h>
14#include <asm/arch/mem.h>
15#include <asm/arch/mux.h>
16#include <asm/arch/sys_proto.h>
17#include <asm/emif.h>
18#include <asm/io.h>
19#include <errno.h>
20#include <i2c.h>
21#include <power/tps65217.h>
22#include <spl.h>
23
24#ifndef CONFIG_SKIP_LOWLEVEL_INIT
25
26static struct ctrl_dev *cdev = (struct ctrl_dev *)CTRL_DEVICE_BASE;
27
28static struct module_pin_mux i2c0_pin_mux[] = {
29 {OFFSET(i2c0_sda), (MODE(0) | RXACTIVE |
30 PULLUDEN | SLEWCTRL)}, /* I2C_DATA */
31 {OFFSET(i2c0_scl), (MODE(0) | RXACTIVE |
32 PULLUDEN | SLEWCTRL)}, /* I2C_SCLK */
33 {-1},
34};
35
36static struct module_pin_mux nand_pin_mux[] = {
37 {OFFSET(gpmc_ad0), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD0 */
38 {OFFSET(gpmc_ad1), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD1 */
39 {OFFSET(gpmc_ad2), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD2 */
40 {OFFSET(gpmc_ad3), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD3 */
41 {OFFSET(gpmc_ad4), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD4 */
42 {OFFSET(gpmc_ad5), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD5 */
43 {OFFSET(gpmc_ad6), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD6 */
44 {OFFSET(gpmc_ad7), (MODE(0) | PULLUP_EN | RXACTIVE)}, /* NAND AD7 */
45 {OFFSET(gpmc_wait0), (MODE(0) | RXACTIVE | PULLUP_EN)}, /* NAND WAIT */
46 {OFFSET(gpmc_wpn), (MODE(7) | PULLUP_EN | RXACTIVE)}, /* NAND_WPN */
47 {OFFSET(gpmc_csn0), (MODE(0) | PULLUDEN)}, /* NAND_CS0 */
48 {OFFSET(gpmc_advn_ale), (MODE(0) | PULLUDEN)}, /* NAND_ADV_ALE */
49 {OFFSET(gpmc_oen_ren), (MODE(0) | PULLUDEN)}, /* NAND_OE */
50 {OFFSET(gpmc_wen), (MODE(0) | PULLUDEN)}, /* NAND_WEN */
51 {OFFSET(gpmc_be0n_cle), (MODE(0) | PULLUDEN)}, /* NAND_BE_CLE */
52 {-1},
53};
54
55static void enable_i2c0_pin_mux(void)
56{
57 configure_module_pin_mux(i2c0_pin_mux);
58}
59
60void chilisom_enable_pin_mux(void)
61{
62 /* chilisom pin mux */
63 configure_module_pin_mux(nand_pin_mux);
64}
65
66static const struct ddr_data ddr3_chilisom_data = {
67 .datardsratio0 = MT41K256M16HA125E_RD_DQS,
68 .datawdsratio0 = MT41K256M16HA125E_WR_DQS,
69 .datafwsratio0 = MT41K256M16HA125E_PHY_FIFO_WE,
70 .datawrsratio0 = MT41K256M16HA125E_PHY_WR_DATA,
71};
72
73static const struct cmd_control ddr3_chilisom_cmd_ctrl_data = {
74 .cmd0csratio = MT41K256M16HA125E_RATIO,
75 .cmd0iclkout = MT41K256M16HA125E_INVERT_CLKOUT,
76
77 .cmd1csratio = MT41K256M16HA125E_RATIO,
78 .cmd1iclkout = MT41K256M16HA125E_INVERT_CLKOUT,
79
80 .cmd2csratio = MT41K256M16HA125E_RATIO,
81 .cmd2iclkout = MT41K256M16HA125E_INVERT_CLKOUT,
82};
83
84static struct emif_regs ddr3_chilisom_emif_reg_data = {
85 .sdram_config = MT41K256M16HA125E_EMIF_SDCFG,
86 .ref_ctrl = MT41K256M16HA125E_EMIF_SDREF,
87 .sdram_tim1 = MT41K256M16HA125E_EMIF_TIM1,
88 .sdram_tim2 = MT41K256M16HA125E_EMIF_TIM2,
89 .sdram_tim3 = MT41K256M16HA125E_EMIF_TIM3,
90 .ocp_config = 0x00141414,
91 .zq_config = MT41K256M16HA125E_ZQ_CFG,
92 .emif_ddr_phy_ctlr_1 = MT41K256M16HA125E_EMIF_READ_LATENCY,
93};
94
95void chilisom_spl_board_init(void)
96{
97 int mpu_vdd;
98 int usb_cur_lim;
99
100 enable_i2c0_pin_mux();
101
102 /* Get the frequency */
103 dpll_mpu_opp100.m = am335x_get_efuse_mpu_max_freq(cdev);
104
105
106 if (i2c_probe(TPS65217_CHIP_PM))
107 return;
108
109 /*
110 * Increase USB current limit to 1300mA or 1800mA and set
111 * the MPU voltage controller as needed.
112 */
113 if (dpll_mpu_opp100.m == MPUPLL_M_1000) {
114 usb_cur_lim = TPS65217_USB_INPUT_CUR_LIMIT_1800MA;
115 mpu_vdd = TPS65217_DCDC_VOLT_SEL_1325MV;
116 } else {
117 usb_cur_lim = TPS65217_USB_INPUT_CUR_LIMIT_1300MA;
118 mpu_vdd = TPS65217_DCDC_VOLT_SEL_1275MV;
119 }
120
121 if (tps65217_reg_write(TPS65217_PROT_LEVEL_NONE,
122 TPS65217_POWER_PATH,
123 usb_cur_lim,
124 TPS65217_USB_INPUT_CUR_LIMIT_MASK))
125 puts("tps65217_reg_write failure\n");
126
127 /* Set DCDC3 (CORE) voltage to 1.125V */
128 if (tps65217_voltage_update(TPS65217_DEFDCDC3,
129 TPS65217_DCDC_VOLT_SEL_1125MV)) {
130 puts("tps65217_voltage_update failure\n");
131 return;
132 }
133 /* Set CORE Frequencies to OPP100 */
134 do_setup_dpll(&dpll_core_regs, &dpll_core_opp100);
135
136 /* Set DCDC2 (MPU) voltage */
137 if (tps65217_voltage_update(TPS65217_DEFDCDC2, mpu_vdd)) {
138 puts("tps65217_voltage_update failure\n");
139 return;
140 }
141
142 /* Set LDO3 to 1.8V and LDO4 to 3.3V */
143 if (tps65217_reg_write(TPS65217_PROT_LEVEL_2,
144 TPS65217_DEFLS1,
145 TPS65217_LDO_VOLTAGE_OUT_1_8,
146 TPS65217_LDO_MASK))
147 puts("tps65217_reg_write failure\n");
148
149 if (tps65217_reg_write(TPS65217_PROT_LEVEL_2,
150 TPS65217_DEFLS2,
151 TPS65217_LDO_VOLTAGE_OUT_3_3,
152 TPS65217_LDO_MASK))
153 puts("tps65217_reg_write failure\n");
154
155 /* Set MPU Frequency to what we detected now that voltages are set */
156 do_setup_dpll(&dpll_mpu_regs, &dpll_mpu_opp100);
157}
158
159#define OSC (V_OSCK/1000000)
160const struct dpll_params dpll_ddr_chilisom = {
161 400, OSC-1, 1, -1, -1, -1, -1};
162
163const struct dpll_params *get_dpll_ddr_params(void)
164{
165 return &dpll_ddr_chilisom;
166}
167
168const struct ctrl_ioregs ioregs_chilisom = {
169 .cm0ioctl = MT41K256M16HA125E_IOCTRL_VALUE,
170 .cm1ioctl = MT41K256M16HA125E_IOCTRL_VALUE,
171 .cm2ioctl = MT41K256M16HA125E_IOCTRL_VALUE,
172 .dt0ioctl = MT41K256M16HA125E_IOCTRL_VALUE,
173 .dt1ioctl = MT41K256M16HA125E_IOCTRL_VALUE,
174};
175
176void sdram_init(void)
177{
178 config_ddr(400, &ioregs_chilisom,
179 &ddr3_chilisom_data,
180 &ddr3_chilisom_cmd_ctrl_data,
181 &ddr3_chilisom_emif_reg_data, 0);
182}
183
184#endif /* CONFIG_SKIP_LOWLEVEL_INIT */