Ryder Lee | d84982d | 2018-11-15 10:07:51 +0800 | [diff] [blame] | 1 | /* |
| 2 | * Copyright (C) 2018 MediaTek Inc. |
| 3 | * Author: Ryder Lee <ryder.lee@mediatek.com> |
| 4 | * |
| 5 | * SPDX-License-Identifier: (GPL-2.0 OR MIT) |
| 6 | */ |
| 7 | |
| 8 | /dts-v1/; |
| 9 | #include "mt7623.dtsi" |
| 10 | |
| 11 | / { |
| 12 | model = "Bananapi BPI-R2"; |
| 13 | compatible = "bananapi,bpi-r2", "mediatek,mt7623"; |
| 14 | |
| 15 | chosen { |
| 16 | stdout-path = &uart2; |
| 17 | tick-timer = &timer0; |
| 18 | }; |
| 19 | |
| 20 | reg_1p8v: regulator-1p8v { |
| 21 | compatible = "regulator-fixed"; |
| 22 | regulator-name = "fixed-1.8V"; |
| 23 | regulator-min-microvolt = <1800000>; |
| 24 | regulator-max-microvolt = <1800000>; |
| 25 | regulator-boot-on; |
| 26 | regulator-always-on; |
| 27 | }; |
| 28 | |
| 29 | reg_3p3v: regulator-3p3v { |
| 30 | compatible = "regulator-fixed"; |
| 31 | regulator-name = "fixed-3.3V"; |
| 32 | regulator-min-microvolt = <3300000>; |
| 33 | regulator-max-microvolt = <3300000>; |
| 34 | regulator-boot-on; |
| 35 | regulator-always-on; |
| 36 | }; |
| 37 | |
| 38 | reg_5v: regulator-5v { |
| 39 | compatible = "regulator-fixed"; |
| 40 | regulator-name = "fixed-5V"; |
| 41 | regulator-min-microvolt = <5000000>; |
| 42 | regulator-max-microvolt = <5000000>; |
| 43 | regulator-boot-on; |
| 44 | regulator-always-on; |
| 45 | }; |
| 46 | |
| 47 | leds { |
| 48 | compatible = "gpio-leds"; |
| 49 | |
| 50 | blue { |
| 51 | label = "bpi-r2:pio:blue"; |
| 52 | gpios = <&gpio 241 GPIO_ACTIVE_HIGH>; |
| 53 | default-state = "off"; |
| 54 | }; |
| 55 | |
| 56 | green { |
| 57 | label = "bpi-r2:pio:green"; |
| 58 | gpios = <&gpio 240 GPIO_ACTIVE_HIGH>; |
| 59 | default-state = "off"; |
| 60 | }; |
| 61 | |
| 62 | red { |
| 63 | label = "bpi-r2:pio:red"; |
| 64 | gpios = <&gpio 239 GPIO_ACTIVE_HIGH>; |
| 65 | default-state = "off"; |
| 66 | }; |
| 67 | }; |
| 68 | }; |
| 69 | |
Weijie Gao | d9506a6 | 2018-12-20 16:12:54 +0800 | [diff] [blame] | 70 | ð { |
| 71 | status = "okay"; |
| 72 | mediatek,gmac-id = <0>; |
| 73 | phy-mode = "rgmii"; |
| 74 | mediatek,switch = "mt7530"; |
| 75 | reset-gpios = <&gpio 33 GPIO_ACTIVE_HIGH>; |
| 76 | |
| 77 | fixed-link { |
| 78 | speed = <1000>; |
| 79 | full-duplex; |
| 80 | }; |
| 81 | }; |
| 82 | |
Ryder Lee | d84982d | 2018-11-15 10:07:51 +0800 | [diff] [blame] | 83 | &mmc0 { |
| 84 | pinctrl-names = "default"; |
| 85 | pinctrl-0 = <&mmc0_pins_default>; |
| 86 | status = "okay"; |
| 87 | bus-width = <8>; |
| 88 | max-frequency = <50000000>; |
| 89 | cap-mmc-highspeed; |
| 90 | vmmc-supply = <®_3p3v>; |
| 91 | vqmmc-supply = <®_1p8v>; |
| 92 | non-removable; |
| 93 | }; |
| 94 | |
| 95 | &mmc1 { |
| 96 | pinctrl-names = "default"; |
| 97 | pinctrl-0 = <&mmc1_pins_default>; |
| 98 | status = "okay"; |
| 99 | bus-width = <4>; |
| 100 | max-frequency = <50000000>; |
| 101 | cap-sd-highspeed; |
| 102 | cd-gpios = <&gpio 261 GPIO_ACTIVE_LOW>; |
| 103 | vmmc-supply = <®_3p3v>; |
| 104 | vqmmc-supply = <®_3p3v>; |
| 105 | }; |
| 106 | |
| 107 | &pinctrl { |
| 108 | ephy_default: ephy_default { |
| 109 | mux { |
| 110 | function = "eth"; |
| 111 | groups = "mdc_mdio", "ephy"; |
| 112 | }; |
| 113 | |
| 114 | conf { |
| 115 | pins = "G2_TXEN", "G2_TXD0", "G2_TXD1", "G2_TXD2", |
| 116 | "G2_TXD3", "G2_TXC", "G2_RXC", "G2_RXD0", |
| 117 | "G2_RXD1", "G2_RXD2", "G2_RXD3", "G2_RXDV", |
| 118 | "MDC", "MDIO"; |
| 119 | drive-strength = <12>; |
| 120 | mediatek,tdsel = <5>; |
| 121 | }; |
| 122 | }; |
| 123 | |
| 124 | mmc0_pins_default: mmc0default { |
| 125 | mux { |
| 126 | function = "msdc"; |
| 127 | groups = "msdc0"; |
| 128 | }; |
| 129 | |
| 130 | conf-cmd-data { |
| 131 | pins = "MSDC0_CMD", "MSDC0_DAT0", "MSDC0_DAT1", |
| 132 | "MSDC0_DAT2", "MSDC0_DAT3", "MSDC0_DAT4", |
| 133 | "MSDC0_DAT5", "MSDC0_DAT6", "MSDC0_DAT7"; |
| 134 | input-enable; |
| 135 | bias-pull-up; |
| 136 | }; |
| 137 | |
| 138 | conf-clk { |
| 139 | pins = "MSDC0_CLK"; |
| 140 | bias-pull-down; |
| 141 | }; |
| 142 | |
| 143 | conf-rst { |
| 144 | pins = "MSDC0_RSTB"; |
| 145 | bias-pull-up; |
| 146 | }; |
| 147 | }; |
| 148 | |
| 149 | mmc1_pins_default: mmc1default { |
| 150 | mux { |
| 151 | function = "msdc"; |
| 152 | groups = "msdc1", "msdc1_wp_0"; |
| 153 | }; |
| 154 | |
| 155 | conf-cmd-data { |
| 156 | pins = "MSDC1_DAT0", "MSDC1_DAT1", "MSDC1_DAT2", |
| 157 | "MSDC1_DAT3", "MSDC1_DAT3", "MSDC1_CMD"; |
| 158 | input-enable; |
| 159 | drive-strength = <4>; |
| 160 | bias-pull-up; |
| 161 | }; |
| 162 | |
| 163 | conf-clk { |
| 164 | pins = "MSDC1_CLK"; |
| 165 | drive-strength = <4>; |
| 166 | }; |
| 167 | |
| 168 | conf-wp { |
| 169 | pins = "EINT7"; |
| 170 | input-enable; |
| 171 | bias-pull-up; |
| 172 | }; |
| 173 | }; |
| 174 | |
| 175 | uart0_pins_a: uart0-default { |
| 176 | mux { |
| 177 | function = "uart"; |
| 178 | groups = "uart0_0_txd_rxd"; |
| 179 | }; |
| 180 | }; |
| 181 | |
| 182 | uart1_pins_a: uart1-default { |
| 183 | mux { |
| 184 | function = "uart"; |
| 185 | groups = "uart1_0_txd_rxd"; |
| 186 | }; |
| 187 | }; |
| 188 | |
| 189 | uart2_pins_a: uart2-default { |
| 190 | mux { |
| 191 | function = "uart"; |
| 192 | groups = "uart2_0_txd_rxd"; |
| 193 | }; |
| 194 | }; |
| 195 | |
| 196 | uart2_pins_b: uart2-alt { |
| 197 | mux { |
| 198 | function = "uart"; |
| 199 | groups = "uart2_1_txd_rxd"; |
| 200 | }; |
| 201 | }; |
| 202 | }; |
| 203 | |
| 204 | &uart0 { |
| 205 | pinctrl-names = "default"; |
| 206 | pinctrl-0 = <&uart0_pins_a>; |
| 207 | status = "okay"; |
| 208 | }; |
| 209 | |
| 210 | &uart1 { |
| 211 | pinctrl-names = "default"; |
| 212 | pinctrl-0 = <&uart1_pins_a>; |
| 213 | status = "okay"; |
| 214 | }; |
| 215 | |
| 216 | &uart2 { |
| 217 | pinctrl-names = "default"; |
| 218 | pinctrl-0 = <&uart2_pins_a>; |
| 219 | status = "okay"; |
| 220 | }; |