blob: 261ed128acd882c996c11114f9d51eb963e435b5 [file] [log] [blame]
Sam Protsenkof9d0fd82016-03-25 16:39:47 +02001#
2# USB Gadget support on a system involves
3# (a) a peripheral controller, and
4# (b) the gadget driver using it.
5#
6# NOTE: Gadget support ** DOES NOT ** depend on host-side CONFIG_USB !!
7#
8# - Host systems (like PCs) need CONFIG_USB (with "A" jacks).
9# - Peripherals (like PDAs) need CONFIG_USB_GADGET (with "B" jacks).
10# - Some systems have both kinds of controllers.
11#
12# With help from a special transceiver and a "Mini-AB" jack, systems with
13# both kinds of controller can also support "USB On-the-Go" (CONFIG_USB_OTG).
14#
15
16menuconfig USB_GADGET
17 bool "USB Gadget Support"
18 help
19 USB is a master/slave protocol, organized with one master
20 host (such as a PC) controlling up to 127 peripheral devices.
21 The USB hardware is asymmetric, which makes it easier to set up:
22 you can't connect a "to-the-host" connector to a peripheral.
23
24 U-Boot can run in the host, or in the peripheral. In both cases
25 you need a low level bus controller driver, and some software
26 talking to it. Peripheral controllers are often discrete silicon,
27 or are integrated with the CPU in a microcontroller. The more
28 familiar host side controllers have names like "EHCI", "OHCI",
29 or "UHCI", and are usually integrated into southbridges on PC
30 motherboards.
31
32 Enable this configuration option if you want to run U-Boot inside
33 a USB peripheral device. Configure one hardware driver for your
34 peripheral/device side bus controller, and a "gadget driver" for
35 your peripheral protocol.
Sam Protsenkoa59a77f2016-04-13 14:20:24 +030036
37if USB_GADGET
38
Sam Protsenko3457bba2016-04-13 14:20:25 +030039config USB_GADGET_ATMEL_USBA
40 bool "Atmel USBA"
41 select USB_GADGET_DUALSPEED
42 help
43 USBA is the integrated high-speed USB Device controller on
44 the AT32AP700x, some AT91SAM9 and AT91CAP9 processors from Atmel.
45
Steve Raee016f0b2016-08-15 17:26:26 -070046config USB_GADGET_BCM_UDC_OTG_PHY
47 bool "Broadcom UDC OTG PHY"
48 help
49 Enable the Broadcom UDC OTG physical device interface.
50
Sam Protsenko3457bba2016-04-13 14:20:25 +030051config USB_GADGET_DWC2_OTG
52 bool "DesignWare USB2.0 HS OTG controller (gadget mode)"
53 select USB_GADGET_DUALSPEED
54 help
55 The Designware USB2.0 high-speed gadget controller
56 integrated into many SoCs. Select this option if you want the
57 driver to operate in Peripheral mode. This option requires
58 USB_GADGET to be enabled.
59
Steve Raef221db02016-06-07 15:35:21 -070060if USB_GADGET_DWC2_OTG
61
62config USB_GADGET_DWC2_OTG_PHY_BUS_WIDTH_8
63 bool "DesignWare USB2.0 HS OTG controller 8-bit PHY bus width"
64 help
65 Set the Designware USB2.0 high-speed OTG controller
66 PHY interface width to 8 bits, rather than the default (16 bits).
67
68endif # USB_GADGET_DWC2_OTG
69
Sam Protsenko3457bba2016-04-13 14:20:25 +030070config CI_UDC
71 bool "ChipIdea device controller"
72 select USB_GADGET_DUALSPEED
73 help
74 Say Y here to enable device controller functionality of the
75 ChipIdea driver.
76
Sam Protsenkoa59a77f2016-04-13 14:20:24 +030077config USB_GADGET_VBUS_DRAW
78 int "Maximum VBUS Power usage (2-500 mA)"
79 range 2 500
80 default 2
81 help
82 Some devices need to draw power from USB when they are
83 configured, perhaps to operate circuitry or to recharge
84 batteries. This is in addition to any local power supply,
85 such as an AC adapter or batteries.
86
87 Enter the maximum power your device draws through USB, in
88 milliAmperes. The permitted range of values is 2 - 500 mA;
89 0 mA would be legal, but can make some hosts misbehave.
90
91 This value will be used except for system-specific gadget
92 drivers that have more specific information.
93
Sam Protsenko3457bba2016-04-13 14:20:25 +030094# Selected by UDC drivers that support high-speed operation.
95config USB_GADGET_DUALSPEED
96 bool
97
Sam Protsenkoaaa4a9e2016-04-13 14:20:26 +030098config USB_GADGET_DOWNLOAD
99 bool "Enable USB download gadget"
100 help
101 Composite USB download gadget support (g_dnl) for download functions.
102 This code works on top of composite gadget.
103
Sam Protsenkoe6c0bc02016-04-13 14:20:30 +0300104if USB_GADGET_DOWNLOAD
105
106config G_DNL_MANUFACTURER
107 string "Vendor name of USB device"
108
109config G_DNL_VENDOR_NUM
110 hex "Vendor ID of USB device"
111
112config G_DNL_PRODUCT_NUM
113 hex "Product ID of USB device"
114
Mugunthan V Nd4a37552016-11-18 11:09:15 +0530115config USBNET_DEVADDR
116 string "USB Gadget Ethernet device mac address"
117 default "de:ad:be:ef:00:01"
118
Sam Protsenkoe6c0bc02016-04-13 14:20:30 +0300119endif # USB_GADGET_DOWNLOAD
120
Sam Protsenkoa59a77f2016-04-13 14:20:24 +0300121endif # USB_GADGET