arch/microblaze/Kconfig

menu "MicroBlaze architecture"
	depends on MICROBLAZE

config SYS_ARCH
	default "microblaze"

config NEEDS_MANUAL_RELOC
	bool "Disable position-independent pre-relocation code"
	default y
	help
	  U-Boot expects to be linked to a specific hard-coded address, and to
	  be loaded to and run from that address. This option lifts that
	  restriction, thus allowing the code to be loaded to and executed from
	  almost any 4K aligned address. This logic relies on the relocation
	  information that is embedded in the binary to support U-Boot
	  relocating itself to the top-of-RAM later during execution.

config STATIC_RELA
	def_bool y if !NEEDS_MANUAL_RELOC

choice
	prompt "Target select"
	optional

config TARGET_MICROBLAZE_GENERIC
	bool "Support microblaze-generic"
	select BOARD_LATE_INIT
	select DM
	select DM_SERIAL
	select OF_CONTROL
	select SUPPORT_SPL
	select SPL_LIBCOMMON_SUPPORT if SPL
	select SPL_LIBGENERIC_SUPPORT if SPL
	select SYSRESET
	select DM_SPI
	select DM_SPI_FLASH
	select SPI
	imply CMD_DM

endchoice

config DCACHE
	bool "Enable dcache support"
	default y

config ICACHE
	bool "Enable icache support"
	default y

source "board/xilinx/Kconfig"
source "board/xilinx/microblaze-generic/Kconfig"

endmenu