| Nishanth Menon | a200f42 | 2023-08-25 13:03:04 -0500 | [diff] [blame] | 1 | # Defconfig fragment to apply on top of am62x_evm_a53_defconfig |
| 2 | |
| 3 | CONFIG_DEFAULT_DEVICE_TREE="k3-am625-beagleplay" |
| 4 | CONFIG_OF_LIST="k3-am625-beagleplay" |
| 5 | CONFIG_SPL_OF_LIST="k3-am625-beagleplay" |
| 6 | CONFIG_BOOTCOMMAND="run set_led_state_start_load;run findfdt; run envboot; bootflow scan -lb;run set_led_state_fail_load" |
| 7 | CONFIG_EXT4_WRITE=y |
| 8 | CONFIG_LZO=y |
| 9 | CONFIG_AUTOBOOT_KEYED=y |
| 10 | CONFIG_AUTOBOOT_PROMPT="Press SPACE to abort autoboot in %d seconds\n" |
| 11 | CONFIG_AUTOBOOT_DELAY_STR="d" |
| 12 | CONFIG_AUTOBOOT_STOP_STR=" " |
| 13 | # Use the Beagleplay env file |
| 14 | CONFIG_ENV_SOURCE_FILE="beagleplay" |
| 15 | # Do not use emmc boot - we will use FS only |
| 16 | CONFIG_SUPPORT_EMMC_BOOT=n |
| 17 | CONFIG_MMC_IO_VOLTAGE=y |
| 18 | # CONFIG_SPL_MMC_IO_VOLTAGE is not set |
| 19 | CONFIG_MMC_UHS_SUPPORT=y |
| 20 | # CONFIG_SPL_MMC_UHS_SUPPORT is not set |
| 21 | CONFIG_MMC_HS200_SUPPORT=y |
| 22 | # CONFIG_SPL_MMC_HS200_SUPPORT is not set |
| 23 | # Enable GPIO control |
| 24 | CONFIG_DM_GPIO=y |
| 25 | CONFIG_SPL_GPIO=y |
| 26 | CONFIG_DA8XX_GPIO=y |
| 27 | CONFIG_CMD_GPIO=y |
| 28 | CONFIG_CMD_GPIO_READ=y |
| 29 | # Enable LEDs |
| 30 | CONFIG_LED=y |
| 31 | CONFIG_LED_GPIO=y |
| 32 | CONFIG_SPL_LED=y |
| 33 | CONFIG_SPL_LED_GPIO=y |
| 34 | # Enable I2C bus |
| 35 | CONFIG_SPL_I2C=y |
| 36 | CONFIG_DM_I2C=y |
| 37 | CONFIG_SYS_I2C_OMAP24XX=y |
| 38 | CONFIG_CMD_I2C=y |
| 39 | # Regulator |
| 40 | CONFIG_DM_REGULATOR=y |
| 41 | CONFIG_DM_REGULATOR_FIXED=y |
| 42 | CONFIG_DM_REGULATOR_GPIO=y |
| 43 | CONFIG_CMD_REGULATOR=y |
| 44 | CONFIG_DM_REGULATOR_TPS65219=y |
| 45 | CONFIG_DM_PMIC=y |
| 46 | CONFIG_PMIC_TPS65219=y |
| 47 | CONFIG_CMD_PMIC=y |
| 48 | # Uses Realtek phy rather than TI phy |
| 49 | CONFIG_PHY_TI_DP83867=n |
| 50 | CONFIG_PHY_REALTEK=y |
| 51 | # No SPI flash on Beagleplay |
| 52 | CONFIG_SPI=n |
| 53 | CONFIG_SPI_FLASH=n |
| 54 | CONFIG_SPL_DM_SPI_FLASH=n |
| 55 | CONFIG_SPL_SPI_FLASH_SUPPORT=n |